Gleason Reel Cable Loop Organizer Installation guide

  • Hello! I'm a chat assistant and I've reviewed the installation instructions for the Gleason Reel Cable Loop Organizer. This document describes how to install and use the cable loop organizer to control cables during high-speed festoon operation. I am here to answer your questions regarding installation, features and usage of the models CLO-02 and CLO-01.
  • How many organizers are required for each loop in the system?
    How is the organizer attached to the cable loop?
    What is the required torque for the nuts during installation?
INSTALLATION INSTRUCTIONS
FESTOON CABLE LOOP ORGANIZER
Model
Number Description
CLO-02 SMALL - 6.5” Dia
CLO-01 LARGE - 9.5” Dia
DESCRIPTION
The Cable Loop Organizer controls cables during high
speed festoon operation, limiting cable slap and loop swings.
It consists of a loop of high strength rubber formed in a
concave shape to match the bottom of the cable loops. One
organizer is required for each loop in the system.
INSTALLATION
1. Hang loop organizer over bottom of cable loop.
2. Insert three round head bolts through holes in bolting plate
and both end of loop (Fig. 1). Add plate to outside and afx
with lock nuts. Torque nuts to 20-25 lb/in. Organizer hangs
loosely on cable loop and is not fastened to cables.
NOTE:
Heads of round head bolts must be on inside
of organizer with lock nuts to outside.
Bulletin # 046007.a
GLEASON REEL CORP.
600 South Clark St.
Mayville, WI 53050
Phone 920-387-4120 • Fax 920-387-4189
/