Brodit 855023 Datasheet

Category
Holders
Type
Datasheet
29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 855023
855023 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288550237
Item no 855023 fits:
Buick LaCrosse 14-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before installing the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the cover of
adhesive tape on the ProClip. Place the ProClip in your hand as shown in the picture. Then press the angled
edge on the right side of the ProClip into the gap between the console sidewall and the padded console edge.
2. Flip the ProClip upward so the angled edge on the right side of the ProClip hooks behind the console sidewall
edge.
3. Please your index finger behind the ProClip and pull it towards you. Then hook the angled edge over the
console edge and into the gap between the console edge and the center console trim.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 855023 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI