10
1. Left Button - Shifts top display
through speedometer, RPM, and
clock.
2. Middle Button - Shifts middle dis-
play through speedometer, RPM,
clock, odometer, trip 1, trip 2, and
engine hours.
3. Right Button - Shifts bottom display
through coolant temperature, bat-
tery voltage, and fuel level.
4. Speedometer/Tachometer Display -
Indicates approximate vehicle speed
in MPH or KM/H when speedome-
ter function is selected, RPM when
tachometer function is selected.
Press the Left Button to change
which parameter is being displayed.
With speedometer selected, press
and hold the Left Button to shift
between standard (MPH/miles/Fahr-
enheit) and metric (km/h/kilometers/
Celsius).
5. Engine Hour Meter/Odometer/Trip
Meter/Speedometer/Tachometer/
Clock Display - Displays engine
hours, odometer, trip meter, speed-
ometer, tachometer, or clock. Press
the Middle Button to change which
parameter is being displayed. The
Engine Hour Meter and Odometer
cannot be reset. To reset the trip
meter, select the Trip Meter; then
press and hold the Middle Button
until the trip meter display reads 0.
With the clock mode selected, press
and hold the Left Button to set the
clock. The option of selecting the
12-hour or 24-hour clock is avail-
able; press the Left Button to alter-
nate between the two modes. Next,
press the Middle Button to set the
clock. Press the Left or Right to set
the hours; then press the Middle
Button to set the minutes. Press the
Left or Right Button to set the min-
utes. When the proper time has been
set, press the Middle Button to
return to the main gauge display.
6. Coolant Temperature/Battery Volt-
age/Fuel Level Display - Displays
coolant temperature, battery voltage,
and fuel quantity. Press the Right
Button to change which parameter is
being displayed. Press and hold the
Right Button to see the actual values
associated with the mode selected.
7. Gear Position Indicator - Indicates if
reverse is selected.
8. Coolant Temperature Indicator -
When the snowmobile is started, this
indicator will flash and LOW TEMP
will be displayed until the engine
reaches operating temperature.
If the coolant temperature rises too
far above proper operating tempera-
ture, the indicator will flash a warn-
ing (alert) and the engine will
“surge” to alert the operator. If the
coolant temperature rises to a critical
point above proper operating tem-
perature, the indicator will cease
flashing and will remain constantly
illuminated.
NOTE: If the indicator is constantly
on, the engine will shut off if vehicle
speed is reduced to 1.5 km-h (0.9
MPH) or slower.
9. High Beam Indicator - The indicator
is on whenever the high beam mode
is selected by the headlight switch.
CAUTION
If the indicator is illuminated, stop the
engine immediately and allow it to cool
down. If unable to either determine or
remedy the problem, take the snowmo-
bile to an authorized Arctic Cat Snow-
mobile dealer for service. If not under
warranty, this service is at the discre-
tion and expense of the snowmobile
owner.