OTC 7919 Operating instructions

  • Hello! I've reviewed the Parts List & Operating Instructions for the OTC Ball Joint Adapter Set 7919. This document provides detailed guidance on using tools like removers, receiving tubes and cups to replace ball joints on Ford 2WD vans. The instructions include safety precautions, step-by-step guidance for removal and installation. I am ready to assist with any questions you might have about these procedures.
  • What is this tool set designed for?
    What safety precautions should I take?
    What components are included in this set?
Sheet No. 1 of 1
Issue Date: Rev. B, 12-21-06
© SPX Corporation
Form No. 106136
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (507) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
Parts List &
Operating Instructions
for: 7919
Ball Joint Adapter Set
Application: Ford 2WD Van Upper & Lower Ball Joints
No. 39976
Receiving Cup
No. 313444
Ball Joint Remover
No. 204508A
Receiving Cup
No. 313968
Remover
No. 222305
Receiving Tube
No. 222304
Receiving Tube
Shaded areas reflect
the last revisions
made to this form.
Safety Precautions
Caution: To prevent personal injury when using these tools,
Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA.
Before repairing a vehicle, block the wheels to prevent the vehicle from
moving.
Check the final alignment of tooling and components before using a C-frame press
to exert pressure.
Parts List & Operating Instructions Form No. 106136, Sheet 1 of 1, Back
Operating Instructions
1. Position the tools as shown to remove or install the upper or lower ball joint.
Note for Installation: Clean
the control arm or knuckle, and coat the I.D. with a suitable lubricant.
2. Tighten the forcing screw until it meets the cup, and check the alignment of all tooling and components.
Continue tightening the forcing screw until the ball joint is removed or installed.
C-frame
(No. 7248; not included)
Removing the Upper Ball Joint Installing the Upper Ball Joint
No. 222305
Receiving
Tube
Receiving Tube
(No. 29505;
not included;
part of No. 7249
Ball Joint Set)
Removing the Lower Ball Joint Installing the Lower Ball Joint
No. 39976
Receiving
Cup
C-frame
(No. 7248;
not included)
No. 222304
Receiving
Tube
No. 313444
Ball Joint
Remover
C-frame
(No. 7248; not included)
No. 313968
Remover
Removing Adapter
(No. 305228; not included;
part of No. 7249
Ball Joint Set)
Removing Adapter
(No. 305228;
not included;
part of No. 7249
Ball Joint Set)
C-frame
(No. 7248;
not included)
No. 204508A
Receiving
Cup
Removing Adapter
(No. 305228; not included;
part of No. 7249
Ball Joint Set)
/