2. Skov
  3. Loading system

Skov Loading system Technical User Guide

  • Hello! I'm here to help you with information about the SKOV climate controller, based on the Technical User Guide I've reviewed. This document provides detailed instructions on how to load system software using a USB stick, and it emphasizes the importance of matching software to hardware variants, as well as testing after software loading. I'm ready to answer your questions about the installation process, testing procedures, or other related topics.
  • How do I load the software?
    What should I do after loading the software?
Loading System Software
Climate controller
Technical User Guide
604272 • 2023-08-31
English For other language variants of this document we refer to:
Español Para otras variantes del idioma de este documento, visite:
Français Pour les versions dans d'autres langues de ce document veuillez consulter:
http://docs.skov.com/
Loading System Software
2 Technical User Guide
1 Product description
The software comes in the form of a USB memory stick, which contains the required variant of the software. The
software is intended for loading into a controller hardware variant from SKOV A/S.
If more than one USB memory stick containing software is provided, it is important to pay attention to getting the
software loaded in the proper hardware variant, so that software as well as hardware supports the required
functionality – e.g. number of MultiSteps and number of relays.
1.1 Installation guide
1.1.1 Loading software
1. Loosen the screws (A) that hold the front panel in place.
2. Lift out the front panel. Make sure not to pull the flat cable so that the plug (B) is damaged.
Figure1: Loading software
3. Unpack the USB stick (C) and label (D) from the box.
4. Place the small accompanying label at the side of the CPU module (E).
5. Insert the USB stick containing the software in the USB port (F) on the CPU module.
Menu button | Settings | Service | Install software
Loading System Software
Technical User Guide 3
Select the required software.
Installation begins.
Settings are automatically saved before the installation starts
and are loaded after the restart.
The controller restarts during installation.
It is VERY important not to disconnect the power supply during installation.
Do not remove the USB memory stick until the installation is fully completed. In other words, when
the graphical user interface is accessible and usable.
1.2 Testing
After loading the software you must make a thorough test to ensure that the system works as intended.See also
the Technical Manual for the house controller.
1.3 Technical data USB
Network
USB USB 2.0 A type
Variant
Controllers BlueControl
Environment
Operating temperature °C (°F) -40 to +40 (-40 to +104)
Temperature, storage °C (°F) -40 to +70 (-40 to +148) – and protected against direct sunlight.
Shipment
Dimensions when packed H x
W x D
mm 340 x 265 x 30
Shipping weight g210
604272 • 2023-08-31 • en-US • Made in Denmark
SKOV A/S • Hedelund 4 • Glyngøre • DK-7870 Roslev
Tel. +45 72 17 55 55 • www.skov.com • E-mail: [email protected]
/