The TLP Pro 320M, TLP Pro 520M, and TLC Pro 521M
all use the same template.
1. Confirm the product to be installed.
2. Before printing, make sure the page is not scaled and
double-check the print settings.
3. Remove the surface cut-out area (gray) from the template.
4. Measure the area removed from the template.
5. Mark the position on the mounting surface where the
touchpanel is being installed.
6. Double-check dimensions and position,
then cut the opening.
7. For furniture mounting, drill 0.15" (3.8 mm) pilot holes
and use #6-32 threaded screws.
P/N 68-2627-01 Rev. C
Cut-Out Template for the Extron
TLP Pro 320M, TLP Pro 520M, and TLC Pro 521M
3.82"
(97.0 mm)
SURFACE
CUT-OUT
AREA
3.82"
(97.0 mm)
5.65" (143.5 mm)
5.51" (140.0 mm)
3.95"
(100.3 mm)
SURFACE
CUT-OUT
AREA
Wall Mounting
Furniture
Mounting
0.39" (9.9 mm)
Outer Edge of
Wallplate Adapter
(Do not cut
this line.)
Outer Edge of
Wallplate Adapter
(Do not cut
this line.)
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
-
1
