3. Settings
Before recording, you can set up the device according to
your requirements.
- In preview mode, press [MENU] to enter settings, then
pressing [MODE] one can to go to MOVIE settings, PICTURE
settings, PLAYBACK mode, SD tool, General settings and E-
dog settings, press [MENU] to exit.
- In setting list, use [▲]/[▼] to navigate the menu, press [OK]
to get the options and confirm the selection.
Video settings
•
Resolution: Select the resolution of recorded video: FHD 1920 x 1080, 720P 1280x720,
WVGA 848 x 480.
•
Loop recording: Set the video duration (1, 3, 5 minutes or off) for loop recording. When
the microSD card is full, the device will delete the oldest unlocked video file
automatically.
•
WDR: Off/On. Turn on or off Wide-dynamic-range.
•
White Balance: Auto, Daylight, Cloudy, Tungsten, Fluorescent. Select an appropriate white
balance, so images have a true-to-life color range. It is for specific lighting situations.
•
Motion Detection: Off, Low Level, Middle Level, High Level. DVR automatically starts
recording when motion is detected in front of camera. Recording stops when there is no
movement any more but a delay of 15-20 seconds. The function works only when power
is supplied.
•
Record Audio: Off/On. Set to record sound or not.
•
Date Stamp: Off/On. Add date stamp onto videos.
•
G-sensor: Off, Low Level, Middle Level, High Level. Select the sensitivity of the G-sensor.
The smaller the number is, the higher the sensitivity is. A recording video file becomes
automatically protected when collision, shake or emergency braking occurs.
PICTURE SETTINGS
•
Resolution: Select the picture image size from 3MP, 2MP, 1.2MP, VGA.
•
Quality: Set the photo quality Fine/Normal/Economy.
•
White Balance: Select an appropriate white balance, so images have a true-to-life color
range. It is for specific lighting situations. Auto, Daylight, Cloudy, Tungsten, Fluorescent.
•
ISO: Set the ISO Auto/100/200/400.