3
User Manual
3. Settings
Before recording, you can set up the device according to your requirements.
- In video/picture preview mode, press [MENU] to enter video/picture
sengs, press it again go the general sengs, press it third me to exit.
- In seng list, use [
]/[ ] to navigate the menu, press [OK] to get the
opons and confirm the selecon, press [MENU] to exit.
Video settings
PICTURE SETTINGS
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3
RoadRunner 526
Resoluon: Select the resoluon of recorded vide
o: FHD 1920 x 1080, 720P 1280x720, WVGA 848
x 480.
Loop recording: Set the video duraon (1, 3, 5 minutes or off) for loop recording. When the
microSD card is full, the device will delete the oldest unlocked video file automacally.
HDR: Off/On. Turn on or off High-dynamic-range. HDR can enhance the brightness in dark, and
adjust the brightness in backlighng.
White Balance: Auto, Daylight, Cloudy, Tungsten, Fluorescent. Select an appropriate white
balance, so images have a true-to-life color range. It is for specific lighng situaons.
Moon Detecon: Off, Low Level, Middle Level, High Level. Turn on or off moon detecon. If
there is any moon detected while the car engine is stopped, your car DVR will start recording
automacally.
Record Audio: Off/On. Set to record sound or not.
Date Stamp: Off/On. Add date stamp onto videos.
G-sensor: Off, Low Level, Middle Level, High Level. Select the sensivity of the G-sensor. The
smaller the number is, the higher the sensivity is. When reaching the sensive value (such as
collision), the recording file will be automacally protected.
Parking Mode: Off/On.
Capture Mode: Set the mer: Without mer, 2S Timer, 5S, Timer, 10 S mer.
Resoluon: Select the picture image size from 2MP, 1.3MP, VGA.
Sequence: Turn off/on photo sequence.
Quality: Set the photo quality Fine/Normal/Economy.
Sharpness: Adjust the sharpness Strong/Normal/So.
White Balance: Select an appropriate white balance, so images have a true-to-life color range. It is
for specific lighng situaons. Auto, Daylight, Cloudy, Tungsten, Fluorescent.
Color: Set the photo color Color/black&white/sepia.
ISO: Set the ISO Auto/100/200/400.
An-Shaking: Off/On.
Date Stamp: Off, Date, Date/Time. Add data stamp onto photos.