2. Poewit
  3. WAP-1
WAP-1

Poewit WAP-1 User guide

  • Hello, I'm your chat assistant. I've reviewed the Quick Start Guide for the PoEWit WAP-1 Wireless Access Point. This document details how to install and set up your device, highlighting features like Wi-Fi 6 support, and 8x8 transmission. I am ready to answer your questions about this device and its initial configuration.
  • What does a blue LAN1 LED indicate?
    What does an amber LAN1 LED indicate?
    What is the default SSID for the 2.4G network?
    What is the default password for the guest 5.0G network?
poewit.com
WITH 8X8
CLOUD-INTELLIGENT
Enterprise-Class | Ultra-High-Density
WI-FI 6 WIRELESS
ACCESS POINT
QUICK START GUIDE
WAP-1
poewit.com
INSTALLATION AND SETUP
1
WARNING
BEFORE PROCEEDING, EXAMINE AP MOUNTING TO ENSURE THERE
IS AN AIR GAP BETWEEN THE BACK OF THE AP HOUSING AND THE
MOUNTING SURFACE. AIR FLOW IS IMPORTANT TO MAINTAINING A
LOW TEMPERATURE.
1) After mounting the WAP-1, connect an Ethernet cable (Cat5/6)
from the LAN1 port to the Router.
• Note: To achieve full power and wireless transmission, ensure
the PoE source is 802.3bt. Features will be limited when using
802.3at.
• Note: A blue LAN1 LED indicates a link of 2.5Gbps. An amber
LED indicates a link of 100/1000Mbps.
2) To configure the device, download the PoEWit App from Google
Play or the Apple App Store.
poewit.com
INSTALLATION AND SETUP
2
• Note: The WAP-1 and the mobile device running the PoEWit
App must be on the same external IP address and the same
local subnet.
3) Once powered On, the WAP-1 will automatically connect to the
internet, and the Power LED will appear blue when the device is
ready for operation.
4) There are two installation scenarios depending on whether or not
there is a wireless network already installed.
4a) With an Existing AP on the Network:
1. Connect to the existing AP using your mobile device.
 2.OpenthePoEWitApptodiscoverandcongurethenewWAP-1.
poewit.com
INSTALLATION AND SETUP
3
4b) With No Existing AP on the Network:
1. Connect to the newly-installed WAP-1 using the default
SSID and Passcode.
Default SSID and Passcode:
 2.OpenthePoEWitApptodiscoverandcongurethenewWAP-1.
3. Once the settings are saved, the WAP-1 will reboot and
lose connection to the mobile device. Allow 30 to 60
seconds for the WAP-1 to reestablish power.
SSID
poewit_2.4G_1
poewit_5.0G_1
poewitguest_2.4G
poewitguest_5.0G
Passcode
3301Andrews
3301Andrews
WelcomeGuest
WelcomeGuest
poewit.com
INSTALLATION AND SETUP
4
4. Once power is restored, connect to the new SSID you setup.
/