Poewit WAP-2O User guide

Brand: Poewit

Model: WAP-2O

Type: User guide

poewit.com

CLOUD-INTELLIGENT

Enterprise-Class | Ultra-High-Density

OUTDOOR

WI-FI 6 WIRELESS

ACCESS POINT

QUICK START GUIDE

WAP-2O

poewit.com

INSTALLATION AND SETUP

1) After mounting the WAP-2O, connect an Ethernet cable (Cat5/6)

from the LAN1 port to the Router.

• Note: A blue LAN1 LED indicates a link of 2.5Gbps. An amber

LED indicates a link of 100/1000Mbps.

• Note: The WAP-2O and the mobile device running the PoEWit ..

App must be on the same external IP address and the same ....

local subnet.

3) Once powered On, the WAP-2O will automatically connect to the

internet, and the Power LED will appear blue when the device is

ready for operation.

4) There are two installation scenarios depending on whether or not

there is a wireless network already installed.

4a) With an Existing AP on the Network:

1. Connect to the existing AP using your mobile device.

poewit.com

INSTALLATION AND SETUP

2. Open the PoEWit App to discover and configure the new

WAP-2O.

4b) With No Existing AP on the Network:

1. Connect to the newly-installed WAP-2O using the default

SSID and Passcode.

poewit.com

INSTALLATION AND SETUP

Default SSID and Passcode:

1. Connect to the newly-installed WAP-2O using the default

SSID and Passcode.

Default SSID and Passcode:

2. Open the PoEWit App to discover and configure the new

WAP-2O.

3. Once the settings are saved, the WAP-2O will reboot and

lose connection to the mobile device. Allow 30 to 60

seconds for the WAP-2O to reestablish power.

4. Once power is restored, connect to the new SSID you setup.

SSID

poewit_2.4G_1

poewit_5.0G_1

poewitguest_2.4G

poewitguest_5.0G

Passcode

3301Andrews

WelcomeGuest

poewit.com

INSTALLATION AND SETUP

Poewit WAP-2O User guide

Poewit WAP-2O User guide

Related papers

Other documents