Model:SK-680AG
The receiver is insert to USB port immediate,
or by a extra USB cable.
USB port
Nano re ceiver
The RF2.4GHz Optical keyboard use two AAA
alkaline battery.
Connect the USB plug to USB port of your computer
Install the batteries in the keyboard
Step1: Remove the battery compartment
cover on the bottom of the keyboard
by squeezing the cover in from the
tab to release it
Step2:Insert the batteries as shown inside
the battery compartment
Step3:Replace the cover
Multimedia Hotkeys functions:
FN+ESC=F1toF12 key switch is the default the Multimedia
or default ofF1toF12 keyswitch
F1:Previous Track
F2:Play/Pause
F4:Mute
F3:Next Track
F6:Volume Up
F7:Web home
F5:Volume Down
F8:Search
F10:My Favorite
F9:Email
F12: computer settings
F11: save
: calculator
RF2.4GHz Auto-Link
Keyboard
I received the keyboard does not work:
1. Plug the receiver again.
2. Please check the keyboard batteries for electric,
watch battery compartments are negative right into
the new battery.
3. Make the keyboard close to plug USB receiver within
30 centimeters, if I found the power indicator light flash,
keyboard to match.
: Reduced display brightness
: Display brightness increase
FCC Warning Statement
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
‐‐Reorient or relocate the receiving antenna.
‐‐Increase the separation between the equipment and receiver.
‐‐Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
‐‐Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
1
SQT Electronics SK-679AG User manual
Fellowes E8HKG-0570 User manual
Primax Electronics RF-BTCMBO2 User manual
Acer Aspire 2000 Owner's manual
Gericom SILVER SERAPH P4 User manual
Shenzhen SMK-643383AG User manual
iHome IH-K220CB User manual
Vizio All-in-One Touch PC Quick start guide
Compaq 27MHz User manual
Kensington K64390US User manual