![](//vs1.manuzoid.com/store/data-gzf/00da6cd86260c954c3a417beea282fd7/2/000955318.htmlex.zip/bg4.jpg)
Attach Studs (E) with Screwdriver (I) to the contact points on the Left arm (D)
Place Chair Seat Panel (B) and Backrest Panel(A) to the Left arm (D) through
the Studs (E).
4 of 5
Turn the Chair rightside.
Adjust the pre-installed feet Levellers until the chair is level with the ground.
Then, proceed to tighten up all screws and bolts.
Your Chair is ready for use.
Align the nut hole and attached with Spring Washers and Washers and Nuts
(F) with the Spanner(H).
Put on the Nut caps(G)
DO NOT OVERTIGHTEN, yet.
4 of 5