HySecurity CBOX Quick start guide

Category
Gate Opener
Type
Quick start guide

HySecurity CBOX is a powerful and versatile gate control system that offers a wide range of features to make your life easier and more secure. With its advanced technology, the CBOX can be used to control a variety of gate types, including swing gates, slide gates, and barrier gates. It is also compatible with a variety of access control devices, such as keypads, card readers, and remote controls.

Some of the key features of the CBOX include:

  • Automatic gate operation: The CBOX can be programmed to open and close your gate automatically at specific times or when triggered by an access control device. This can help to improve security and convenience.

HySecurity CBOX is a powerful and versatile gate control system that offers a wide range of features to make your life easier and more secure. With its advanced technology, the CBOX can be used to control a variety of gate types, including swing gates, slide gates, and barrier gates. It is also compatible with a variety of access control devices, such as keypads, card readers, and remote controls.

Some of the key features of the CBOX include:

  • Automatic gate operation: The CBOX can be programmed to open and close your gate automatically at specific times or when triggered by an access control device. This can help to improve security and convenience.
Mercury 310 / SolarBOX / Apollo 816
Quick Start Installation Guide
11
MX5133-01 Rev. B ©2021
CAUTION! Do NOT weld while control board is powered!
Attach Actuator
to Pivot Arm Attach Gate Bracket
to Actuator Arm
Washer
Actuator Arm
Gate Bracket
Fig-1: Pivot Arm, Actuator, & Gate Bracket
Gate Bracket
Apollo 816 Actuator
Ensure
Actuator is Level
Pivot Arm
6
7
10
9
CAUTION! Do not mount the control box where the person
using the push button on box can come in contact with the gate!
1/2”x 2-7/8”Bolt
1/2”x 3.5” Bolt
Pivot Arm
Actuator
Lock Nut Lock Nut
Mount Control Box same side as primary
actuator and min. 6 feet away from pivot arm.
Place Battery inside control box (terminals
facing toward the front).
2
Connect
battery
and solar
panels to
Mercury
controller.
See image
on next
page.
Set 816 Actuator Mechanical Limits:
1. Remove plastic caps from limit adjust
screws on 816 motor rear (see image).
2. Use arrow button to run gate to open limit (gate
stops & both LEDs light on Mercury controller).
3. Select screw to adjust gate position as follows:
If arm extended, use Extend Screw (CCW =
extend more, CW = extend less)
If arm retracted, use Retract Screw (CCW =
retract less, CW = retract more)
4. Use arrow button to run gate to close limit (gate
stops & both LEDs light on Mercury controller)
and adjust position per Step 3.
5. Replace plastic caps over screws.
Less
(CCW)
More
(CW)
Retract Screw
More
(CCW)
Less
(CW)
Extend Screw
Weld or clamp pivot arm onto hinge post. For Pull-to-Open installation, use Detail A. For Push-to-Open, use Detail B:
Gate
Push-To-Open
Pull-to-Open
Actuator And Control Box Installation (perform ALL steps in numerical order):
FRONT VIEW FRONT VIEW
IMPORTANT!
Read entire
manual before
attempting the
installation.
This is NOT a
“do-it-yourself”
project. Use
a qualied
contractor
to install this
system. Read
all safety
information!
1
Gate Bracket
Centerline
Top of
Pivot Arm
1/2”
Pivot
Arm
Hinge
Post
Gate
Gate Bracket
Centerline
Top of
Pivot Arm
1/2”
Pivot
Arm
Hinge
Post
Gate
Or
11
PIVOT ARM
Hinge
Post
Hinge Gate
6”
6”
13”
PIVOT ARM
Hinge
Post
Hinge Gate
TOP VIEW TOP VIEW
A B
PULL PUSH
Closed
Closed
Pull-To-Open Bracket Position
GATE OPEN
8
Pass single gate
actuator cable
through grommets in
control box bottom
and wire as shown.
For dual gate, dig
trench across drive,
run 2nd cable through
conduit, & wire as
shown.
Apollo 816
Actuator Wiring:
Ax Gate
Bracket
to gate
structural
support by
welding or
using
bolt/nut.
5
4
Pull-To-Open:
Fully open gate,
then locate bracket
on gate support.
Push-To-Open:
Fully close gate, then
locate bracket on
gate support. Bracket
Bracket
Ensure actuator arm is fully retracted, then position gate
bracket on gate structural support per Detail A or Detail B:
Gate Closed
Gate Open
Wall
Wall
B
A
Install
actuator to
pivot arm with
bolt and lock
nut as shown. 3
Install gate bracket to
actuator arm end with
bolt, washer, & lock
nut, as shown. Do not
attach bracket to gate
until Step 5.
Pull-To-Open
Push-To-Open
Mercury 310 / SolarBOX / Apollo 816
Quick Start Installation Guide
22 support.hysecurity.com
6 foot min.
from pivot
install
12V Solar Panel
BlueBUS
Photo Eye
Open
Limit Open
Limit
Close
Limit
6
14
7
13
13 13
11
1
2
Fig-2: Apollo 816 Dual-Gate System (Pull-To-Open Shown)
Fig-3: Mercury 310 Controller Features
9
N.O.
+V
+V
+V
+V
N.O.
N.O.
N.O.
N.O.
N.O.
N.C.
COM
COM
COM
COM
N.O.
COM
N.O.
COM
10K
Safety
Sensors
Loop Detectors
BlueBUS
+12 VDC
+12 VDC
(OFF in Standby)
+12 VDC
Guard
Station
Controls
(Step Mode)
Remote
Input
Fire Dept.
(Emergency
Access)
Control
N.O.
Control
Control
LOOP 1
(Obstruct)
LOOP 2
(Shadow)
LOOP 3
(Exit)
18-24V DC/
12V Solar 12V
Battery
Actuator Motor Connections
+
+_
_
+12 VDC
(OFF in Standby)
COM
Step Button
Open Button
Latch Button
Fail-Safe Button
(On/Off)
Alarm Button (On/Off)
Battery Health LED
Alarm
Battery Fuse
(30A)
DC/Solar Fuse (15A)
Battery Power
Indicator LED
DC/Solar Power
Indicator LED
OXI Radio Port
Radio Program:
Display
Arrow Buttons
Left & Right
Function
Knob
Firmware
Update (Motor 1/Motor 2)
(Open, Close, Stop/Clear)
Gate Control Buttons
Open/Close Limit LEDs
Mercury 310 Power Outputs
Location Voltage Amps Standby Mode
INPUTS
12VDC 500 mA
On
SENSORS
LOOPS On
OUTPUTS
R
U
N
L
E
A
F
D
E
L
A
Y
C
L
O
S
E
T
I
M
E
R
L
R
N
M
O
T
O
R
1
F
O
R
C
E
L
R
N
M
O
T
O
R
2
Mercury 310 Power Requirements
> Battery = 12VDC sealed lead acid
> Solar panel = 12V (17-20V MPP)
> DC input = 18-24V high current
Gate Limit Learn Procedure:
1. Set function knob to LRN MOTOR 1
(display ashes L1).
2. Use Left/Right buttons to “jog” gate
to between open and close limits.
3. Press/hold both left and right buttons
for two (2) seconds.
4. Display will show solid L1 and gate
will run at crawl speed to rst limit.
5. After reaching rst limit, display
ashes between OP and CL (LEDs
also ash).
6. Observe current position of the gate
and do only one of the following:
If gate is at open limit, press the
open button.
If gate is at close limit, press the
close button.
7. Gate auto-runs to 2nd limit at crawl
speed & stops, then runs to 1st limit
at normal speed & stops, then runs
to the 2nd limit at normal speed &
stops.
8. When finished, display will show
either OP or CL, depending on
buttons pressed during procedure.
9. If dual gate, set function knob to
LEARN MOTOR 2 (display ashes
L2) & repeat all steps for 2nd motor.
11 14
13
12
button on remote control, then
within 2 seconds press & release
the STEP, OPEN, or LATCH button
on Mercury controller. LED ashes
twice & alarm chirps to indicate
progamming success.
safety devices. See controller accessory
inputs in the image below.
Attach warning signs to
gate(s).
To program the OXI
receiver, press/hold
desired
Connect other accessories, such as
loop detectors, photo eyes, or other
Perform Gate Limit Learn procedure
(below right).
CAUTION! Do
not mount the
control box where
the person using
the push button
on box can come
in contact with the
gate!
!
10 12
12V
10
12
10
12
Actuator Cable
LEGEND
BlueBUS Wiring
Loop Wiring
Solar Panel Wiring
3
5
4
Conduit for BlueBUS
and 2nd actuator cable
8
Vehicle Loop
  • Page 1 1
  • Page 2 2

HySecurity CBOX Quick start guide

Category
Gate Opener
Type
Quick start guide

HySecurity CBOX is a powerful and versatile gate control system that offers a wide range of features to make your life easier and more secure. With its advanced technology, the CBOX can be used to control a variety of gate types, including swing gates, slide gates, and barrier gates. It is also compatible with a variety of access control devices, such as keypads, card readers, and remote controls.

Some of the key features of the CBOX include:

  • Automatic gate operation: The CBOX can be programmed to open and close your gate automatically at specific times or when triggered by an access control device. This can help to improve security and convenience.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI