CEM Fume Cabinet Installation guide

Hello! I've reviewed the CEM Fume Cabinet Installation Instructions. This document outlines the steps to properly install the Discover module and fume cabinet onto the automated sample deck base, including securing with M5 screws and connecting the exhaust hose and power cord. I'm ready to assist with any questions you may have about the installation process or the device itself.
What is the first step in installing the fume cabinet?

What type of screws are used?

When should screws be fully tightened?

CEM Fume Cabinet Installation Instructions

1. Position the Discover module into the automated sample deck base using the track in the base as a positioning

guide.



2. InstallanM5screwontherightandleftrearsidesoftheautomatedsamplemodule(Explorer).Donot

completelytightenthescrewsatthistime.



3. Placethefumecabinetontheautomatedsampledeckbasefromtherear,aligningthecabinetwiththe

openingsforthescrewsinstalledinstep2.





Corporation

600393

Rev. 1

8/2013

4. InstallanM5screwontherightandleftfrontsidesoftheautomatedsamplemodule.



5. Tightenallfourscrewsinstalledinsteps2and4.



6. Attachtheexhausthosetotheblowerassemblyandattachthepowercord.

  

/

Related papers

Other documents