Genaray LED-2100 User manual

Brand
Genaray
Model
LED-2100
Type
User manual

Genaray LED-2100 is an on-camera light with 25' lighting range and 65° illumination angle, ideal for photographers and videographers. It features an integrated shoe mount for easy attachment to DV & HDSLR cameras, and can also be mounted on a tripod using the included 1/4 20 camera mounting bracket. The LED-2100 has a built-in diffuser for even light dispersion and is stackable, allowing you to connect multiple units for increased illumination. With two included 700mAh Li-Ion rechargeable 1-hour batteries, you can enjoy extended use without worrying about running out of power.

Genaray LED-2100 is an on-camera light with 25' lighting range and 65° illumination angle, ideal for photographers and videographers. It features an integrated shoe mount for easy attachment to DV & HDSLR cameras, and can also be mounted on a tripod using the included 1/4 20 camera mounting bracket. The LED-2100 has a built-in diffuser for even light dispersion and is stackable, allowing you to connect multiple units for increased illumination. With two included 700mAh Li-Ion rechargeable 1-hour batteries, you can enjoy extended use without worrying about running out of power.

MANUAL
LED-2100 - USER MANUAL
KEY FEATURES
·Integrated Shoe Mount
Connects To DV & HDSLR
Cameras
·Unit Has 25' Lighting Range &
65° Illumination Angle
·Stackable Mounting Feature
Interlocks With Other Units
·Mounting Bracket Connects To
1/4 20 Camera Tripod Screw
POWERING LED LIGHT
·Open latch found on battery compartment
cover by squeezing tab upwards; hold tab
in upward position and remove the entire
cover
·Install fully-charged battery by sliding it into
battery compartment; ensure that gold-
colored battery conductor contacts face
upwards and are touching metal
prongs in the battery mounting area
·Replace battery compartment cover
·Move the power switch into the
ON position to illuminate the LEDs
MOUNTING LED LIGHT ON CAMERA
·Begin by positioning light unit directly
atop camera or video camera
·Ensure that locking ring is fully loosened
and slide cold shoe mount into shoe of
camera; rotate ring clockwise to lock light
into place securely
MOUNTING LED LIGHT ON BRACKET
·Included mounting bracket is designed for
point-and-shoot cameras that have no shoe
mount; begin by mounting light on cold shoe
found on bracket
·Insert 1/4 20 screw found on bracket into
the 1/4 20 threading mount found on bottom
of camera; adjust spacing of camera by
sliding knob along length of bracket arm
and secure tightly
INTERLOCKING WITH OTHER LED UNITS
·Ensure that device locking ring is fully
loosened and slide cold shoe mounting
into interlocking expansion slot of another
compatible Genaray LED light unit; rotate
ring clockwise to lock light in place securely
·Up to 3 compatible Genaray LED light units
can be mounted to each individual light unit
or in a stacked vertical format for increased
illumination
·Do not attempt to disassemble,
repair or perform any
unauthorized modifications on
device
·Do not handle with wet hands,
immerse in liquids or expose to
water and rain; electric shock
or fire may result
·Device contains small parts
which may pose a choking
hazard; keep out reach of
children
·Do not operate device in
presence of flammable gas or
vapors
·Do not use product if it emits
smoke or a strange odor;
disconnect power source
immediately to avoid personal
injury and contact place of
purchase
·Observe caution when handling
batteries; only use batteries
approved by the manufacturer
of this product
·Batteries are prone to leakage
when fully discharged; to avoid
damaging product be sure to
remove batteries when leaving
product unattended
·Do not intentionally stare or
gaze at LED light panel for
prolonged periods while device
is on
·Do not use or leave device in
conditions of extreme heat,
severe cold or high humidity
·Unit will display a decrease in
brightness when the battery
runs low; be sure to replace
battery when necessary to
avoid affecting recording quality
·When cleaning the device, use
only a mild detergent solution
and quickly wipe dry with a
soft cloth
·Please dispose of used
batteries, packaging and old
devices in accordance with
appropriate environmental
regulations
SAFETY WARNINGS
LED-2100
USER MANUAL
INTRODUCTION
Thank you for choosing the Genaray LED-2100 On-Camera Light. This
product will provide you with powerful, portable and dependable illumination
that can be used in a variety of settings. Featuring advanced light dispersion
capabilities and supporting accessories that add instant versatility to this
light kit, the Genaray LED-2100 On-Camera Light proves to be the perfect
choice for photographers and videographers alike.
PRODUCT CONTENTS
1 - LED Light With Built-In
Diffuser & Shoe Mount
1 - Thread Adapter for Sony
AIS Shoe Mount
1 - Included Camera Mounting Bracket
2 - 700mAh Li-Ion Rechargeable
1-Hour Batteries
1 - 110-240V AC/DC Wall Charger
1 - European Plug Adapter
LIMITED 1 YEAR WARRANTY
See website for details
www.genaraylighting.com
Built-In
Diffuser
LED
Array
Locking
Ring
Interlocking
Expansion
Slots
Cold Shoe
Mount
Power
Switch
1/4 20
Threaded
Mount Battery
Compartment
Cover
CUSTOMER SUPPORT
Please send email
correspondence to:
info@genaray.com
  • Page 1 1

Genaray LED-2100 User manual

Brand
Genaray
Model
LED-2100
Type
User manual

Genaray LED-2100 is an on-camera light with 25' lighting range and 65° illumination angle, ideal for photographers and videographers. It features an integrated shoe mount for easy attachment to DV & HDSLR cameras, and can also be mounted on a tripod using the included 1/4 20 camera mounting bracket. The LED-2100 has a built-in diffuser for even light dispersion and is stackable, allowing you to connect multiple units for increased illumination. With two included 700mAh Li-Ion rechargeable 1-hour batteries, you can enjoy extended use without worrying about running out of power.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents