Addendum 5
RPM and RCF update and 5-position rack (MPA) inspection
6
Inspecting the 5-position racks (MPA)
The system operates with two types of 5-position rack (MPA):
• Rack type 1: Holds sample tubes of up to 13.4 mm in diameter.
• Rack type 2: Holds sample tubes of up to 16.3 mm in diameter.
Each rack type holds up to 5 primary sample tubes, and has a working lifetime of 7 years.
Inspection intervals
This section is in addition to section Accessories > 5-position Racks (MPA) and rack trays
(page B-35) of the cobas p 671 centrifuge unit (67x) v2.0 operator’s manual.
The 5-position rack (MPA) may crack, deform or break through overuse, resulting in
possible test tube breakages.
Carefully inspect all racks for cracks, structural deformity, damage and breakage,
according to the frequencies described in Table 3
, below, and discard all defective 5-
position (MPA) racks immediately following identification.
Centrifuge
specifications
1
Inspection interval
and day
[Lifetime: 4200 cycles / 7
years]
day
[Lifetime: 6300-16800
cycles / 7 years]
day
[Lifetime: 18900 – 29400
cycles / 7 years]
within lifetime
Ø16mm: no inspection
within lifetime
Ø16mm: Every 6 months
Ø16mm: Every 3 months
3700
3120
Ø16mm: Every 6 months
Ø16mm: Every 2 months
Ø16mm: Every 1.5
months
4500
4620
Ø16mm: Every 1 month
Ø16mm: Every 2 weeks
Ø16mm: Every 7 days
Table 3: Inspection intervals
1
Radius of rotation axis: 204 mm