2. BLOTZ
  3. B00-ACC-100

BLOTZ B00-ACC-100 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ B00-ACC-100 12 Turn Counter. This document outlines how to assemble the counter including the base plate, top plate and pointer and provides guidance on using glue and a knife. I'm ready to answer any questions you have about its assembly or features.
  • What type of glue is required?
    What tool is needed to remove sections?
    Is glue used to attach the pointer to the base?
12 Turn Counter (Japanese)
B00-ACC-100
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the base and top plate from the sprue.
Glue them together, aligning the sides, ensuring you
do not get any glue in the central hole.
Take the three pieces of the pointer from the sprue.
Glue the smaller disk below the larger one, aligning
the slots and then push the upright through to
secure them in place.
Place (do not glue) the pointer to the base section.
1
5
9
2
6
10
3
7
11
4
8
12
/