2. S.R.Smith
  3. Sentry Lifeguard Chair

S.R.Smith Sentry Lifeguard Chair Assembly Instructions

  • I have reviewed the assembly instructions for the S.R. Smith Life Ring Hook 13-504. This document outlines the necessary steps and components for installing the life ring hook, including the tools needed. I am prepared to answer any questions you may have about the assembly process or the product itself.
  • What tools are required for assembly?
    What is included in the Life Ring Hook Kit?
    Where should the Life Ring Hook be installed?
06-190 Nov 17
Life Ring Hook
LIFE RING HOOK KIT # 13-504
1. Insert Bolt (3) through Washer (2),
Life Ring Hook (1), and into rear
chair leg as seen in Figure A.
Tighten with 7/16 wrench.
Do not overtighten.
BILL OF MATERIALS
ITEM # PART # DESCRIPTION QTY.
1 4-173PW Life Ring Hook PWDR
White, Sentry 1
2 5-159 ¼” Flat Washer 316 SS 2
3 5-203 ¼” x 1” Lag Screw 316SS 2
SRS AUSTRALIA, PTY LTD
12 Enterprise St
Richlands QLD 4077
Australia
Phone 07 3812 2283 • Fax 07 3812 1187
www.srsmith.com/au
S.R. SMITH, LLC
CORPORATE HEADQUARTERS
P.O. Box 400 • 1017 S.W. Berg Parkway
Canby, Oregon 97013
USA
Phone (503) 266 2231 • Fax (503) 266 4334
www.srsmith.com
LIFEGUARD STAND
LIFE RING HOOK
FIGURE A
A
SSEMBLY INSTRUCTIONS
Visit srsmith.com for information on the complete
line of S.R. Smith pool products.
Tools Required: 7/16 Wrench
/