Greenes Fence RCEV2448P Operating instructions

Type
Operating instructions

This manual is also suitable for

PACKAGE CONTENTS + (4) Screws & Fabric Liner
.
CONNECT LEG POSTS TOGETHER WITH FLOOR SUPPORT BLOCKS
Stand two Leg Posts upright. Holding both ends of a Floor Support
Block with the notched ends facing up, slide both ends into the
grooves of the Leg Posts with even pressure, all the way to the
bottom. Connect the remaining Leg Posts and Floor Support
Blocks the same way, with long and short Floor Support Blocks
opposite each other to form the rectangular frame.
.
DROP IN FLOOR BOARDS
Lay the Floor Boards side by side on the ledge created by the Floor
Support Blocks, leaving a gap between each Board for drainage.
If using the Fabric Liner, fold or cut it to size and lay on top of the
Floor Boards. It will stay in place when soil is added.
.
FINISH WALLS & ATTACH DECORATIVE CAPS
Now stack the remaining Side Wall Boards as shown in Step 2
to finish the walls. Attach each Decorative Cap to a Leg Post with
a screwdriver and one Screw. We recommend drilling a pilot
hole first for each Screw.
.
DROP IN FIRST SIDE WALL BOARD
Stack one Side Wall Board over each Floor Support Block.
Tap both ends of the Side Wall Board evenly so it slides securely
down between the Leg Posts. If needed, tap snugly into place with
a rubber mallet.
Questions? Email info@greenesfence.com or call 800-622-5510 Monday - Friday 8am-5pm EST
ORIGINAL CEDAR ELEVATED GARDEN BED | ASSEMBLY INSTRUCTIONS
x4 x13 x4
Leg
Posts
Floor Support
Blocks
(2) long
(2) short
Side Walls
(6) long
(6) short
Floor
Boards
Decorative
Caps
x12
NEED HELP?
Contact Customer Service instead
of returning item to store.
800-622-5510 M
F 8
5
info@greenesfence.com
x4
MODEL #
RCEV
DIMENSIONS
2ft. wide x 4ft. long
x 31in. high
  • Page 1 1

Greenes Fence RCEV2448P Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI