PACKAGE CONTENTS + (4) Screws
.
CONNECT LEG POSTS TOGETHER WITH FLOOR SUPPORT BLOCKS
Stand two Leg Posts upright. Holding both ends of a Floor Support
Block with the notched ends facing up, slide both ends into the
grooves of the Leg Posts with even pressure, all the way to the
bottom. Connect the remaining Leg Posts and Floor Support
Blocks the same way to form the square frame.
.
DROP IN FLOOR BOARDS
Lay the Floor Boards side by side on the ledge created by the Floor
Support Blocks, leaving a gap between each Board for drainage.
If using the Fabric Liner, fold or cut it to size and lay on top of the
Floor Boards. It will stay in place when soil is added.
.
FINISH WALLS & ATTACH DECORATIVE CAPS
Now stack the remaining Side Wall Boards as shown in Step 2
to finish the walls. Attach each Decorative Cap to a Leg Post
with a screwdriver and one Screw. We recommend drilling a
pilot hole first for each Screw.
.
DROP IN FIRST SIDE WALL BOARD
Stack one Side Wall Board over each Floor Support Block.
Tap both ends of the Side Wall Board evenly so it slides
securely down between the Leg Posts. If needed, tap snugly
into place with a rubber mallet.
Questions? Email info@greenesfence.com or call 800-622-5510 Monday - Friday 8am-5pm EST
ORIGINAL CEDAR ELEVATED GARDEN BED | ASSEMBLY INSTRUCTIONS
x4 x4 x4
Leg
Posts
Floor Support
Blocks
Side Walls Floor
Boards
Decorative
Caps
x8
NEED HELP?
Contact Customer Service instead
of returning item to store.
800-622-5510 M
–
F 8
–
5
info@greenesfence.com
x4
MODEL #
RCEV
DIMENSIONS
16in. wide x 16in. long
x 31in. high
/