PAC CAM-TY11 User manual

CAM-TY11

Reverse Camera T-Harness for Select

Toyota, Scion, Subaru Vehicles

Pacic Accessory Corporation

| Santa Ana, California 92705 | Ph. 866-931-8021 | [email protected]

www.pac-audio.com

Rev. 1.0

Pacific Accessory Corporation

Page 1

Introduction & Features

Installation

Applications

Illustration / Schematic

The CAM-TY11 is a reverse camera T-harness that gives the ability to add a reverse camera input for compatible TOYOTA,

SCION, and SUBARU 6.1” touchscreen radios. Simple plug and play installation.

1. Dis-assemble dash and remove the radio.

2. Unplug 16 pin plug shown in pictures below. Install the T-harness as shown.

3. The harness will provide 6 volt power output, if you are using a camera that is NOT capable of being powered by 6 volts, you

must nd your own source of 12 volt ACC power.

4. Camera must have power before the vehicle is placed into reverse, so using the reverse lamp power source is not an option.

5. No reverse trigger is needed, as long as the camera has power when the vehicle is placed into reverse, the radio will automatically

switch to the reverse camera image.

Radio Connector T-Harness

2012-2014 TOYOTA

4-Runner, Avalon, Camry, Highlander, Prius 3,

Prius C, Prius V, Rav-4,Venza

2013-2014 SCION FRS

2013 SCION XB

2013-2014 SUBARU BRZ