INSTRUCTIONS MANUAL
FLUORESCENT CEILING FLUSH MOUNT
FIXTURE
Page 1
HOME DEPOT SKU# 848-889 (UPC# 046335920439)
Page 2
Thank you for purchasing this Hampton Bay Fluorescent Ceiling Flush
Mount Fixture. This product has been manufactured with the highest
standards of safety and quality.
FEATURES:
Before returning to your local Home Depot, please call our Customer
Service Team at 1-877-527-0313 or visit www.homedepot.com. Please
reference your SKU (848-889) or UPC (046335920439).
QUESTIONS, PROBLEMS, MISSING PARTS:
1. Easy to install.
2. ENERGY STAR
®
qualified
Page 3
CAUTION:
1. Before starting installation of this fixture or removal of a previous
fixture, disconnect the power by turning off the circuit breaker or by
removing the fuse at the fuse box.
2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY
ELECTRICAL QUESTIONS. If you have any non-electrical
questions about this fixture, please call our Customer Service Team at
1-877-527-0313 or visit www.homedepot.com. Please reference your
SKU (848-889) or UPC (046335920439).
3. KEEP your receipt and these Instructions for Proof of Purchase.
TOOLS REQUIRED FOR INSTALLATION AND ASSEMBLY (not
included):
Safety
goggles
Wire
strippers
Phillips
screwdriver
Electrical
tape
Wire
cutters
Drill ¼” Drill
bit
Pencil
Hammer
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
ASSEMBLY INSTRUCTIONS:
Page 4
1. Carefully unpack the fixture. Lay out all parts on a clean surface.
2. Before continuing Assembly, please proceed to the Installation
Instructions.
3. Connect the provided 32 W Fluorescent Light Bulbs (#2) to the
Ballast Lamp Connectors (#4). Attach both Fluorescent Light Bulbs
(#2) to the Fixture Pan (#1) by snapping them into the provided
Lamp Clips (#5). (Fig. 1)
4. Secure the Acrylic Lens (#3) and Frame (#20) to the Fixture Pan (#1)
using the Thumb Nuts (#19), as shown. (Fig. 2)
1 ea Fixture Pan (#1)
2 ea 32 W Fluorescent
Light Bulb(#2)
4 ea Thumb Nuts (#19)
1 ea Acrylic Lens (#3)
1 ea Frame (#20)
ASSEMBLY:
Page 5
5. Lamp
Clip
2. 32 W Fluorescent
Light Bulb
4. Ballast
Lamp
Connector
1. Fixture Pan
Fig. 1
3. Acrylic Lens
1. Fixture Pan
19. Thumb Nuts
Fig. 2
20. Frame
Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
INSTALLATION INSTRUCTIONS:
3 ea Wire Nuts (#10) 4 ea Mounting Screws (#8)
1. Place the Fixture Pan (#1) onto the desired location, centering it over
the Outlet Box (#6). Mark the location of all the Keyhole Slots
(#16).
2. Remove the Fixture Pan (#1) from the Ceiling (#7). Drill
appropriately sized Holes (#17) at the marked keyhole locations.
Insert the Ceiling Anchors (#18) into the Holes (#17). (Fig. 3)
3. Thread the Mounting Screws (#8) halfway into the Ceiling Anchors
(#18). (Fig. 3)
4. Pull the power supply wires out from the Outlet Box (#6). Attach the
Black Supply Wire (#14) to the Black Fixture Wire (#15) and the
White Supply Wire (#9) to the White Fixture Wire (#11) using Wire
Nuts (#10). Connect the Fixture Ground Wire (#12) and the Supply
Ground Wire (#13) together using a Wire Nut (#10). (Fig. 4) Wrap
all wire connections with electrical tape for a more secure
connection. Note: If you have electrical questions, consult your local
electrical code for approved grounding methods.
4 ea Ceiling Anchors (#18)
INSTALLATION INSTRUCTIONS (CONT.):
5. Carefully tuck all wire connections into the Outlet Box (#6). Place
the Fixture Pan (#1) onto the desired location, making sure that the
halfway threaded Mounting Screws (#8) feed through the large
openings of the Keyhole Slots (#16). Slide the Fixture Pan (#1) so
that the Mounting Screws (#8) slide into the narrow slots of the
Keyhole Slots (#16). Tighten the Mounting Screws (#8) down to
secure the Fixture Pan (#1) in place. (Fig. 5 & 5-1)
6. Proceed to Step 3 of the Assembly Instructions.
7. Installation is complete. Turn on power at the circuit breaker or fuse
box. Turn the light switch on to activate the fixture.
Page 7
Page 8
INSTALLATION:
Fig. 3
18. Ceiling
Anchor
1. Fixture Pan
7. Ceiling
17. Hole
6. Outlet Box
Fig. 4
11. White
Fixture Wire
10. Wire Nut
9. White
Supply Wire
14. Black Supply Wire
13. Supply
Ground Wire
15. Black Fixture Wire
6. Outlet Box
7. Ceiling
1. Fixture Pan
8. Mounting
Screw
12. Fixture Ground Wire
Page 9
INSTALLATION (CONT.):
6. Outlet Box
1. Fixture
Pan
7. Ceiling
Fig. 5
16. Keyhole
Slot
8. Mounting
Screw
16. Keyhole
Slot
Bottom View
Fig. 5-1
18. Ceiling
Anchor
8. Mounting
Screw
Possible Cause Corrective Action
1. Power is off. 1. Make sure power supply is on.
2. Faulty switch. 2. Test or replace switch.
3. Faulty wire connection. 3. Check wiring.
Fuse blows or circuit breaker
trips when light is turned on.
1. Crossed wires or power wire is grounding
out.
1. Check wire connections.
Light will not turn on.
TROUBLESHOOTING:
PRODUCT MAINTENANCE:
1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean
water, never a solvent) to wipe the surface of the fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the
circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly
dampened clean cloth (use clean water, never a solvent) to wipe the interior surface of the
fixture.
3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft
cloth to dust or wipe carefully.
LIMITED WARRANTY
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a
period of three (3) years from date of purchase. This warranty applies only to the original consumer
purchaser and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the
manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident,
modifications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found
to have been improperly installed, set-up, or used in any way not in accordance with the instructions
supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident,
misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material
or workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface
and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and
specially disclaims any warranty, whether expressed or implied, of fitness for a particular purpose,
other than the warranty contained herein. The manufacturer specifically disclaims any liability and
shall not be liable for any consequential or incidental loss or damage, including but not limited to any
labor/expense costs involved in the replacement or repair of said product.
Page 10
LUMINARIO DE TECHO CON LUZ
FLUORESCENTE
HOME DEPOT SKU# 848-889 (UPC# 046335920439)
MANUAL DE INSTRUCCIONES
Page 11
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
MODE D’INSTALLATION
PLAFONNIER À LUMIÈRE
FLUORESCENTE
HOME DEPOT UGS Nº 848-889 (CUP Nº 046335920439)
Page 21
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
