2. TRUE FINE
  3. TD60006OT
TD60006OT

TRUE FINE TD60006OT User manual

  • Hello! I am an AI chatbot trained to assist you with the TRUE FINE TD60006OT User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Why does the light fixture not turn on?
    What is the correct way to clean the interior of the fixture?
    What is the proper way to clean the exterior of the fixture?
    How do I install the fixture?
Instruction Manual
Outdoor Wall Sconce
TROUBLESHOOTING:
Possible Cause Corrective Action
3. Faulty wire connection.
1.Power is off.
2.Faulty switch.
1.Make sure power supply is on.
2.Test or replace switch.
3. Check wiring.
Fuse blows or circuit breaker
trips when light is turned on.
1. Crossed wires or power wire is
grounding out. 1. Check wire connections.
Light will not turn on.
PRODUCT MAINTENANCE:
1.To clean the outside of the fixture,use a dry or slightly dampened clean
cloth (use clean water ,never a solvent) to wipe the surface of the fixture.
2.To clean the inside of the fixture, first disconnect power to the fixture by
turn off the circuit breaker or by removing the fuse at the fuse box.
Next, use a dry or slightly dampened clean cloth (use clean water,
never a solvent) to wipe the interior surface of the fixture.
3.Do not use any cleaners with chemicals, solvents or harsh abrasives.
Use only a dry soft cloth to dust or wipe carefully.
Customer Service: [email protected]
CAUTION: To avoid any waterproofing problems, please make sure the
light fixture fits the mounting surface perfectly installation and use
waterproof glue around the canopy for better sealing after installation.
Print in china
Installation
TOOLS REQUIRED FOR INSTALLATION
AND ASSEMBLY (not included):
Safety
goggles
Wire
strippers
Phillips
screwdriver
Electrical
tape
Wire
cutters
Flathead
screwdriver
WARNING:Installation must be performed by a
qualified licensed electricion
DANGER:Before installation,ture off the main
power at the circuit breaker.
1.Removing the existing fixture
A.Tuck the fixture wires into the ceiling box,attached the mounting
plate(C) to the ceiling box and fix them with 2 mounting screws(A).
B. Align the 2 screws(B) through the holes of the back plate(D),
and fix them with screw nuts(E).
C. Install bulb (G) (Not included)to the socket, place glass shade (H) and
cap (I) to fixture body (F), then fix them with screw nut (J).
A.Remove the existing fixture.
2.Connecting the wires
A.Connect the white supply wire to the white fixture wire.
B.Connect the black supply wire to the black fixture wire.
C.Connect the ground supply wire to the ground fixture wire.
D.Use wire nuts to secure all connections.
3.Installing the fixtures
Mounting plate
Mounting screw
Print in china
A
E
C
BDF
G
H
I
J
/