2. Lincoln Manufacturing
  3. 1101

Lincoln Manufacturing 1101 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Lincoln Manufacturing 1101 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Grill Tender
®
Operator Instructions
Model 1101
HOW TO USE
Quickly and easily remove carbonized food from your grill surface with the Redco
®
Grill Tender
®
. Equipped with a
splashguard and an extra-long handle that is positioned above the grill, the Redco
®
Grill Tender
®
scraper offers
added protection from burns.
1. With one hand on the Handle Casting (see illustration on next page) and other hand on the Knob, place the
Redco
®
Grill Tender
®
scraper on the grill surface. With a firm front-to-back motion, scrap the carbonized
food particles from the grill surface.
2. Repeat steps as needed to keep the grill surface clean.
3. Clean the Redco
®
Grill Tender
®
scraper after each use to maintain optimum performance and extend the
life of the blade.
P/N: 2802386 REV: C
This machine contains a sharp blade and can cause serious injury or death if not handled properly. All
operators of this equipment should read these operating instructions before handling equipment.
!
CAUTION:
!
Prior to each use check for broken, nicked or dull blades and if found, replace the blade.
Prior to using this equipment, it is important to clean the unit. Wash new blades with warm soapy water and
rinse thoroughly to remove the thin protective oil film.
CLEANING & BLADE REMOVAL INSTRUCTIONS
CLEANING
1. Wash the Grill Tender
®
Scraper in mild soap and hot water.
2. Rinse and air dry.
BLADE REMOVAL
1. Loosen the Pressure Plate Retaining Set Screws with an Allen Wrench.
2. Carefully remove the Blade and Pressure Plate from the unit. Properly dispose of the old blade.
3. Carefully align the replacement blade and pressure plate into the groove of the Head Section Casting.
4. With the pressure plate and blade in place, firmly tighten the set screws to securely fasten the blade and
pressure plate to the Head Section Casting.
PARTS LIST
LETTER PART NUMBER DESCRIPTION
A 1102R Blade, Single G.T.S.
B 1108R Head Section Casting / Handle
C 1109R Knob Assembly includes Knob and Bolt
D 1106R Blade Pressure Plate
E 1107R Pressure Plate Retaining Set Screw
Lincoln Foodservice Products, LLC
1111 North Hadley Road
Fort Wayne, Indiana 46804
United States of America
www.lincolnsmallwares.com
Telephone: (260) 459-8200
Technical Support Hotline: (800) 678-9511
A
D
C
B
C
E
/