Page is loading ...
75MM
75MM
75MM 75MM
100MM
100MM
100MM 100MM
M4 x 10
M5 x 10
COMPATIBILITY CHECKER
VESA 50
Fittings
VESA 75
Fittings
VESA 100
Fittings
VESA 200 x 100 Fittings
This TV bracket is designed to t LCD TV’s and computer monitors with VESA 50, VESA 75, VESA
100 and VESA 200x100 bracket ttings. These standard ttings are found on almost all systems
although some may vary - in which case you may need to contact the TV manufacturer for assist-
ance.
To check if your TV or monitor is com-
pliant, look at the back of your system
and check it has four mounting holes
spaced in any of the combinations
shown.
FLAT-TO-WALL LCD TV MOUNT
Part No. 28071R
Installation Instructions
WARNING!!!!
Correct assembly is essential
This mount should be tted to solid wood, brick or concrete wall
Note: We have not supplied wall xings with this product. All walls differ in strength and
thickness. We advise that you consult professional personell for guidance for purchasing
screws designed specically for your type of wall.
turn over for installation instructions...
BACK OF TELEVISION
BACK OF TELEVISION
BACK OF TELEVISION
BACK OF TELEVISION
WALL
WALL
WALL
WALL
VESA 50/75/100 TYPE FITTINGS
VESA 200 x 100 TYPE FITTING
STEP ONE - Preparing the wall ttings
Mark and drill four holes in your wall to allow mounting of the bracket at the four holes marked on the diagram below.
Fit wall screws to your wall according to the wall structure (seek professional advise before attempting to install) leaving
2-3mm gap between the screw head and the wall surface. This allows the plate to slide onto the screws.
STEP TWO - Fitting to the television
Once you have checked the compatibility of your television, locate the tting holes on the mounting plate that match your
televisions mounting holes. See black tting holes marked on the diagram below.
Check which type of the supplied tting screws t your television (M4 or M5) and attach the plate rmly to the back of
your television.
STEP THREE- Fitting to the wall
Now that the mount is securely fastened to the television, lift the television onto the wall screws using the keyhole wall
tting holes shown in STEP ONE.
If the television feels loose on the wall, lift the mount off the wall screws and tighten them to decrease the gap between
the screw head and wall.
VESA 50/75/100 TYPE FITTINGS
VESA 200 x 100 TYPE FITTING
Customer Careline: 0901 293 0038
Calls are charged at £1 per minute from a BT landline. Call charges from other networks may vary
Support: http://technical.philex.com
v2
/