2. Duinotech
  3. XC3735

Duinotech XC3735 Owner's manual

  • Hello! I've reviewed the user guide for the jaycar XC3735 FP2Y0A02YK0F Distance sensor. It describes a sensor that measures distances from 20 to 150 cm and outputs an analog signal. The guide also includes details on how to integrate it with Arduino. I'm ready to answer your questions about the device.
  • What is the distance range of the sensor?
    What type of output does the sensor provide?
    What is the typical supply voltage?
    What is the current consumption of the sensor?
    What is the maximum delay between sample reading and output?
Australia New Zealand
www.jaycar.com.au www.jaycar.co.nz
[email protected] [email protected]
1800 022 888 0800 452 922 Page 1 of 1
XC3735 User Guide
IR Distance Sensor
Hardware
The XC3735 Distance sensor utilises a Sharp FP2Y0A02YK0F IR Emitter and sensor to
give an analogue signal relating to distance.
Specifications
Distance
20 to 150 cm
Output
Analog reading
Size
92.5 x 13 x 21.6 mm
Current
33 mA Typical
Supply voltage
5V typical
Delay between sample
reading and output
5ms max.
Programming in Arduino
Use analogRead() calls to read the connected analogue pin, once you have set the
pinMode as INPUT.
Output voltage by Distance chart
Note that this is for guide only.
/