1
Unpack printer
Notes:
• Place the printer near the computer
during setup. If you're setting up on
a wireless network, then you may
move the printer after setup is
complete.
• Do not attach the USB cable until
prompted to do so.
• The packaged printhead is shipped
inside the printer.
• Contents may vary by model and
region.
2
Remove tape and packing material from all areas of the
printer
Lexmark Pro800 Series Installation
3
Open printer and remove packaged printhead
4
Close printer
5
Pull paper tray completely out of printer
Lexmark Pro800 Series Installation
6
Move paper guides to the sides
7
For A4 or Legal, extend paper tray
8
Load paper and adjust paper guides
Note: Do not load paper past the
maximum height indicator line as shown
in step 2.
Lexmark Pro800 Series Installation
9
Insert paper tray
10
Connect power cord only
Note: DO NOT attach the USB cable yet.
CAUTION—POTENTIAL INJURY: Read the safety information included with this product before connecting
power or making any cabling connections.
11
Make sure printer is on
Lexmark Pro800 Series Installation
12
Follow prompts on the printer control panel
1 Follow the prompts on the printer
control panel.
2 After following the prompts, click
Continue below.
13
Install printhead and ink cartridges
If you need to install the printhead and
cartridges, click Continue.
If not, you can close this window.
14
Open printer and remove any tape from latch
Note: The carriage moves to the
printhead installation position as shown.
Lexmark Pro800 Series Installation
15
Squeeze and lift latch
16
Remove printhead from disposable container
17
Insert printhead and close latch until it clicks
Lexmark Pro800 Series Installation
18
Close printer
19
Open printer
Note: The printhead moves to the
cartridge installation position as shown.
20
First, insert each color ink cartridge. Then, use two hands
to install black cartridge.
Lexmark Pro800 Series Installation
21
Close printer
22
Flip and extend exit tray paper stop
Notes:
• Extend the paper exit tray for
A4/Legal.
• The paper stop holds paper as it exits
the printer.
23
Touch OK to print alignment page
Notes:
• Do not remove the page until
printing stops. The alignment page
may take a while to print and will
move in and out during the process.
• Streaks on the alignment page are
normal and not an indication of a
problem.
• The alignment page that prints may
differ from the one shown.
• Recycle the alignment page.
Lexmark Pro800 Series Installation
/
