Goldmund LOGOS 3N User manual

USER MANUAL

GOLDMUND LOGOS 3N

Active

SUB-BASS SPEAKER

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 2

Thank you for purchasing the Goldmund Logos 3N.

The Goldmund Logos line fully incorporates the technological expertise developed by our

company throughout many years. Please take some time to read this manual. It may

provide you with useful information to make your pleasure of listening to the Logos 3N

Subwoofer even higher.

INTRODUCTION

GOLDMUND LOGOS 3N – ACTIVE SUB-BASS SPEAKER

Goldmund was founded in 1978 and has ever since been dedicated to the accurate

reproduction of sound and image.

At Goldmund, we strive to lead in the creation, development and manufacture of the

industry’s most advanced technologies, including audio and video systems.

The guiding principle at Goldmund is to produce a precise sound with the least possible

loss of quality through the different stages. Goldmund will never adopt a technology before

it is sufficiently developed to satisfy the high quality standards we set. This is why

Goldmund has often rejected mainstream technologies and developed its own.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 3

Table of Contents

1

11

1

PRELIMINARIES

PRELIMINARIESPRELIMINARIES

PRELIMINARIES

5

55

5

2

2 2

2

UNPACKING

UNPACKINGUNPACKING

UNPACKING

5

55

5

3

33

3

LOGOS 3N LOCALISATION

LOGOS 3N LOCALISATIONLOGOS 3N LOCALISATION

LOGOS 3N LOCALISATION

6

66

6

5

55

5

RUNNING

RUNNINGRUNNING

RUNNING-

--

-IN THE LOGOS 3N

IN THE LOGOS 3NIN THE LOGOS 3N

IN THE LOGOS 3N

7

77

7

6

66

6

MAITENANCE AND CLEANING

MAITENANCE AND CLEANINGMAITENANCE AND CLEANING

MAITENANCE AND CLEANING

8

88

8

7

77

7

TECHNICAL DATA

TECHNICAL DATATECHNICAL DATA

TECHNICAL DATA

8

88

8

88

8

GENERAL SAFETY INSTRUCTION

GENERAL SAFETY INSTRUCTIONGENERAL SAFETY INSTRUCTION

GENERAL SAFETY INSTRUCTION

10

1010

10

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 4

W A

W A W A

W A R N I N G

R N I N G R N I N G

R N I N G !

!!

!

Only careful use can provide the

satisfaction you are expecting from this

product.

All handling must be performed according to

the following instructions to avoid deterioration

of the speaker.

Nevertheless, if the instructions are carried out

in full, you will notice that the use of the Logos

3N is quite simple and convenient.

IMPORTANT: PLEASE DO NOT CONNECT

ANY CABLES OR MOVE ANY PART BEFORE

READING THE FOLLOWING

INSTRUCTIONS.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 5

1

11

1

PRELIMINARIES

PRELIMINARIESPRELIMINARIES

PRELIMINARIES

The Goldmund Logos 3N uses very innovative technology to achieve an unique level of

definition and neutrality in a sub-bass speaker system.

Please read very carefully the following instructions. This high-precision speaker is

extremely revealing and can provide the best effects only if it is used properly.

2

2 2

2

UNPACKING

UNPACKINGUNPACKING

UNPACKING

The Logos 3N requires special attention during unpacking, the speaker is quite heavy, so

we recommend the unpacking and installation of this unit to be performed by two persons.

Some handling steps necessitate a lot of care.

ATTENTION

If you need to return the subwoofer to the factory or to your local representative for a

warranty repair, please note that it must be repacked in the original packing. This

packaging has been designed especially to protect the speaker in transit. Use of alternative

packaging will almost inevitably result in damage, which cannot be covered by the warranty.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 6

3

33

3

LOGOS

LOGOS LOGOS

LOGOS 3

33

3N

NN

N LOCALISATION

LOCALISATION LOCALISATION

LOCALISATION

For optimal sonic result, it is essential that vibrations arising within the Logos 3N be

evacuated to the ground effectively. Solid coupling with a very rigid floor is an essential

element in this process.

Preserve space around the speaker to provide proper cooling.

We recommend using the Logos 3N with the Logos 1N and Logos 2N in a Full Logos

Active System.

4

44

4

C

CC

CONNECTING THE BUILT

ONNECTING THE BUILTONNECTING THE BUILT

ONNECTING THE BUILT-

--

-IN AMPLIFIER

IN AMPLIFIERIN AMPLIFIER

IN AMPLIFIER

The Logos 3N input is an unbalanced digital input (S/PDIF). The S/PDIF digital signal

presents two channels (Left and Right). By default the channel left is set from factory.

The Logos 3N uses a full digital filtering, the filters are made by software inside the acoustic

processor (Metis 8, 10, Mimesis 15, 16/16HD, 32) with the standard or personalized

configuration file provided by the Goldmund Universal Configurator.

The signal is treated with the Proteus technology with all its corrections. The Logos 3N has

no active filtering (hardware filter).

Only an official Goldmund representative is able to load and change the configuration file

into your acoustic processor, do not change it by yourself.

A wrong setting can damage the speakers; the warranty will not cover any factory change

without the approval of an official Goldmund representative.

ATTENTION The Logos 3N can only work in association with a Goldmund Acoustic

Processor: Metis 8, Metis 10, Mimesis 15, Mimesis 16/16HD, and Mimesis 32.

Please check the Goldmund webpage to learn more about the units we offer

(www.goldmund.com)

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 7

4

44

4

CONNECTING THE BUILT

CONNECTING THE BUILTCONNECTING THE BUILT

CONNECTING THE BUILT-

--

-IN AMPLIFIER

IN AMPLIFIERIN AMPLIFIER

IN AMPLIFIER

(Ctd)

(Ctd)(Ctd)

(Ctd)

The digital filter is carried out inside the acoustic processor.

Connect the digital cable to the digital input connector. Since a digital Spdif cable carries 2

channels, you may link the digital output to the next speaker to transfer the second channel.

The Logos 3N is automatically powered ON when it receives modulation. When the digital

input does not receive any data for 3 seconds, the subwoofer is muted. It is de-muted as

soon as a signal is present on the digital input and the orange led will light up.

Main power must not to be removed while the Logos 3N is not muted (please wait 3

seconds after the music stops before removing the mains power).

5

55

5

RUNNING

RUNNINGRUNNING

RUNNING-

--

-IN

ININ

IN THE LOGO

THE LOGO THE LOGO

THE LOGOS

S S

S 3

33

3N

NN

N

The Logos 3N has been tested at the factory. However, as any high quality speaker

system, the Logos 3N needs several days playing music before reaching the top sonic

quality they are built for. The few first hours can be very frustrating for a demanding

listener.

Do not hesitate to let them play quite loud for some time before attempting any real system

tuning or position adjustment.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 8

6

66

6

MAITENANCE AND CLEANING

MAITENANCE AND CLEANINGMAITENANCE AND CLEANING

MAITENANCE AND CLEANING

To clean the metal case of the speaker, you can use a clean, soft, damp cloth. Dampen

with water or a mild detergent solution. Avoid abrasive or harsh cleansers (e.g. Products

containing sodium carbonate).

The identification plate is plated with precious metal. Simply clean it with a soft cloth,

without any chemical solution.

7

77

7

TECHNICAL DATA

TECHNICAL DATA TECHNICAL DATA

TECHNICAL DATA

The Logos 3N is fully constructed in metal with implementation of the mechanical grounding

system to evacuate vibrations.

BACK PANEL CONTROLS

BACK PANEL CONTROLSBACK PANEL CONTROLS

BACK PANEL CONTROLS

• Digital input

• Digital output

• ON/OFF switch

• Orange locking led

FREQUENCY BANDWIDTH

FREQUENCY BANDWIDTHFREQUENCY BANDWIDTH

FREQUENCY BANDWIDTH

• 10 Hz - 125 Hz (-10dB)

SPEAKER SYSTEM BEHAVIOR

SPEAKER SYSTEM BEHAVIORSPEAKER SYSTEM BEHAVIOR

SPEAKER SYSTEM BEHAVIOR

• Acoustic Filter System

DRIVERS

DRIVERSDRIVERS

DRIVERS

• 30 cm active driver and 30 cm passive radiator used to increase the low frequency

response and selected for their high linearity and dynamics.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 9

7

77

7

TECHNICAL DATA (Ctd)

TECHNICAL DATA (Ctd)TECHNICAL DATA (Ctd)

TECHNICAL DATA (Ctd)

A

AA

AMPLIFIER

MPLIFIERMPLIFIER

MPLIFIER

• Built-In 150 W Telos Amplifier

• Amplifier dynamic Range: > 100 dB (no weighting)

VOLTAGE

VOLTAGEVOLTAGE

VOLTAGE

• Nominal range: 117V or 234V (+/-10%)

• Internal Fuses:

- 8A slow-blow type for 110V & 220V

SIZE AND WEIGHT

SIZE AND WEIGHTSIZE AND WEIGHT

SIZE AND WEIGHT

• 37 W x 37 H x 47 D (cm) - 45 kg net

WARRANTY

WARRANTYWARRANTY

WARRANTY

•

3 years parts and labor.

ATTENTION

: the warranty will not cover any factory change without the approval of an

official Goldmund representative.

Information and product specifications contained in this manual are subject to change without

prior notice. Updated versions of this manual will be posted on our website at

www.goldmund.com.

Please visit our support page at

http://www.goldmund.com/support/register

to register your

Goldmund product for warranty.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 10

8

88

8

GENERAL SAFETY INSTRUCTION

GENERAL SAFETY INSTRUCTIONGENERAL SAFETY INSTRUCTION

GENERAL SAFETY INSTRUCTION

1. Read instructions. Read the safety and operating instructions before operating the

appliance.

2. Retain instructions. Retain the safety and operating instructions for future reference.

3. Heed warnings. Observe all warnings on the appliance and in the operating

instructions.

4. Follow instructions. Follow all operating and use instructions.

5. Water and moisture. Do not use the appliance near water, for example near a

bathtub, in a wet basement, or near a swimming pool and the like.

6. Carts and stands. Use only with a cart or stand that is recommended by the

manufacturer. An appliance and card cart combination should be used with care.

Quick stops, excessive force, and uneven surfaces may cause the appliance and

cart combination to overturn.

7. Wall or ceiling mounting is not recommended for this unit.

8. Ventilation. Site the appliance so that its location or position does not interfere with

its proper ventilation.

9. Heat. Site the appliance away from heat sources such as radiators, heaters, stoves,

or other appliances (including amplifier) that produce heat.

10. Power sources. Connect the appliance to a power supply only of the type described

in the operating instructions or marked on the appliance.

11. Grounding and polarization. Do not defeat the safety purpose of the polarized or

grounding type plug. A polarized plug has two blades with one wider than the other.

A grounding type plug has two blades and a third grounding prong. The wide blade

or the third prong are provided for your safety. When the provided plug does not fit

into your outlet, consult an electrician for replacement of the obsolete outlet.

12. Power cord protection. Route power cords so that they are not likely to be walked on

or pinched by items placed upon or against them, paying particular attention to

cords at plugs, power sockets, and at the point where they exit from appliance.

13. Protective attachment plug. As a safety feature the product is equipped with an

attachment plug containing overload protection. See the instruction manual about

resetting or replacing the plug. Should the plug need replacing ensure that a

replacement is used which has the same overload protection as the original.

14. Cleaning. The product should be cleaned only as recommended by the

manufacturer.

15. Power lines. An outdoor antenna should be located away from power lines.

GOLDMUND LOGOS 3N -

SUB-BASS SPEAKER - 11

8

88

8 GENERAL SAFETY INSTRUCTION (Ctd.)

GENERAL SAFETY INSTRUCTION (Ctd.)GENERAL SAFETY INSTRUCTION (Ctd.)

GENERAL SAFETY INSTRUCTION (Ctd.)

16. Outdoor antenna grounding. If an outdoor antenna is connected to the

tuner/receiver ensure that the antenna system is grounded to provide some

protection against voltage surges and static build up.

17. In the USA see article 810 of the National Electrical Code ANSI/NFPA 70

concerning installation requirements.

18. Unplug this apparatus during lightning storms or when unused for long periods of

time.

19. Objects and liquid entry. Take care not to let objects or liquids fall into the product.

20. Damage requiring service. The product should be serviced by qualified personnel if:

a. The power cord or plug has been damaged.

b. Objects or liquid have fallen into the product

c. The product has been exposed to rain

d. The product does not appear to operate normally or exhibits a marked

change in operation.

e. The product has been dropped or the enclosure damaged

21. Servicing. Do not attempt to service the product beyond that described in the

operating instructions. All other servicing should be referred to qualified service

personnel.

Rev

B

Goldmund LOGOS 3N User manual

Goldmund LOGOS 3N User manual

Related papers

Other documents