Noble House 305109 Operating instructions

Brand
Noble House
Model
305109
Type
Operating instructions

This manual is also suitable for

Label Picture Description QTY
A Backrest 1
B Seat 1
Caution : You must read this before you proceed
Chair
Page 1 OF 6
C Right Armrest / Leg 1
D Left Armrest /Leg 1
E Seat Cushion 1
Label Picture Description QTY
F Bolt(M6*35MM) 11
G Washer 11
H Allen Key 1
Before
Beginning
Assembly:
Page 2 OF 6
Overview
This Chair has multiple parts and may require up to some 30 minutes to assemble. To
give you an overview of the Chair parts, the above picture is to help you put the various
parts into perspective. Please read through the instructions herebelow to familiarise
yourself with the parts and steps before assembly.
Step 1
Open the carton and place all the parts onto a clean and soft surface.
Unpack all packages of hardware.
Place the Backrest (A) with its inside facing skywards.
Attach Seat(B) to Backrest(A) using Hardware(H, G) with Allen Key(H).
Do not fully tighten the bolts.
ATTENTION: Occasionally some of the PE Wicker shifts and covers the mounting
positions preventing easy assembly.
The PE wicker should never be cut, but moved away from the mounting positions.
Backrest(A)
Seat(B)
Right Armrest / Leg(C)
Left Armrest / Leg(D)
Seat Cushion(E)
Page 3 OF 6
Step 2
Place the Right Armrest/Leg(C), as picture above so as to be attached to the Backrest (A)
and Seat(B) using Hardware(F, G) with Allen Key(H).
Do not fully tighten the bolts.
Step 3
Place the Left Armrest/Leg (D) as pictured above and affix to Backrest (A) and Seat(B)
using Hardware(F, G) with Allen Key(H) as shown in Picture 4 and Picture 5.
Do not fully tighten the bolts.
Page 4 OF 6
Step 4
Stand CHAIR rightside up.
Check stability and then tighten the bolts.
Note: DO NOT fully tighten a BOLT in one go and then move on to the next. Rather,
In a sequential manner, gradually tighten each Bolt until all bolts are evenly
secured. This methodology will ensure maximum evenness once all Bolts are fully
tightened.
Step 5
Put the Seat Cushion(E) on the Seat.
Your Chair is ready for use.
The Chair can only be used on a flat and level surface.
Page 5 OF 6
What is Proposition 65?
Proposition 65 is a California law that requires warning labels on products that may
contain one of more than 800-plus chemicals or ingredients that the California Office of
Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or
other reproductive toxicity. Chemicals and elements on this list include wood dust, brass,
and other everyday substances, which can be found in very common household items,
such as: lamps, tableware, jewelry, crystal glasses, electric cords, beauty products,
automobiles, and furniture.
Why Did I Find a Proposition 65 Warning on My Home Goods Product?
We include Proposition 65 warnings on all of our products because there is always a
chance that one of the 800-plus common chemicals and ingredients listed under this law
could potentially be on our furniture or packing materials. We risk large fines under this
law, if we don't include this warning.
Should I worry?
We realize you may be worried finding this warning on our products, but we want to
reassure you that the hazardous exposure limits for any of these chemicals have never
been found on furniture products that we’ve shipped to our customers. Additionally, this
warning label is very common and can be found on almost every piece of furniture sold in
the state of California.
Just How Common Are Proposition 65 Warnings?
Proposition 65 warnings have become so common in California that it is hard to take a trip
to a local bank, grocery store, or restaurant without finding at least one warning. In fact,
even the Disney Land Resort has a Proposition 65 warning:
Page 6 OF 6
TABLE
CAUTION : This Table is NOT a TOY.
Keep your child / children at bay during the assembly process.
For moving the Table and to prevent damage to the Table, two adults are
needed to execute this action.
Caution: You must read this before you process
Label Picture
Description
QTY
①
②
③
④
⑤
Short Bolts (M8x55mm)
Sleeve Nut (M8x20mm)
Long Bolts (M6x90mm)
Screw (M7x45mm)
Allen key
5
5
2
9
2
5
Iron washer
A
B
C
D
E
1
1
1
1
1
Label
Picture
Description
QTYLabel
Table Top
First Leg Frame (with
Leveler)
Second Leg Frame (with
Leveler)
Lower Cross Block
Upper Cross Block
6
Before Beginning Assembly:
This Table has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Table parts, the above picture is to help you put the various parts into perspective.
Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Table Top (A)
Second Leg
Frame (C)
First Leg
Frame (C)
Lower Cross Block (D)
Upper Cross Block (E)
FRONT FACING
Step 1
Unpack and place all parts on a clean, non-marring surface.
With the assistance of your partner, position the First Leg Frame(B) to the
Second Leg Frame © as picture above.
Secure First Leg Frame(B) with the Second Leg Frame (C) by using
Long Bolt ( ) and Allen Key ( ).③ ⑤
. Note: This step, legs with leveler will be upside down
Do not fully tighten the Bolts.
Step 2
c
B
B
c
Step 3
With the assistance of your partner, position the Lower Cross Block (D) onto
the Leg Frames in Step 2. Secure by using Screws ( ) and the Allen Key ( ).④ ⑤
Do not fully tighten the Screws.
Step 4
With the assistance of your partner, turn Leg Frame in step 3 180 degree.
Position the Upper Cross Block (E) onto the Leg Frame as picture above.
Secure by using Screws ( ) and the Allen Key ( ).④ ⑤
Do not fully tighten the Screws.
D
E
Step 5
Place Table top (A) with its underside skywards onto a clean, soft surface
to avoid any scratch or damage to the product.
Position Leg Frame in step 4 onto Table Top (A)
Using two Short Bolts ( ), two Sleeve Nuts ( ), two Iron Washer ( ) and 5.1)
① ②
⑥
Allen Key ( ) to connect middle support bar of Table Top (A) and Leg Frame (B & C).
⑤
Using two Short Bolts( ), two Sleeve Nuts ( ), two Iron Washer ( ) and 5.2)
① ②
⑥
Allen Key ( ) to connect side support bar of Table Top (A) and Leg Frame (B & C).
⑤
Do not fully tighten the Bolts.
Step 6
With assistance from your adult partners, turn the Table back to normal flat
ground
EXERT pressure, floorwards, onto the Table.
This pressure will help the Legs and Table Top reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Screws and Bolts until evenly
secured.
Inspect the Table and make sure all parts are adequately connected.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
LEVELER
STEP 5.1 STEP 5.2
Questions & Answers about Proposition 65
·
What is Proposition 65?
Proposition 65 requires businesses to provide warnings to Californians about significant
exposures to chemicals that cause , birth defects or other . These
chemicals can be in the products that Californians purchase, in their homes or workplaces, or
that are released into the environment. By requiring that this information be provided,
Proposition 65 enables Californians to make informed decisions about their exposures to these
chemicals.
Proposition 65 also prohibits California businesses from knowingly discharging significant
amounts of listed chemicals into sources of drinking water.
Proposition 65 requires California to publish a list of chemicals known to cause , birth
defects or other . This list, which must be updated at least once a year, has
grown to include approximately 900 chemicals since it was first published in 1987.
What types of chemicals are on the Proposition 65 list?
The list contains a wide range of naturally occurring and synthetic chemicals that include
additives or ingredients in pesticides, common household products, food, drugs, dyes, or
solvents. Listed chemicals may also be used in manufacturing and construction, or they may be
byproducts of chemical processes, such as motor vehicle exhaust.
What does a warning mean?
If a warning is placed on a product label or posted or distributed at a workplace, a business, or
in rental housing, the business issuing the warning is aware or believes that it is exposing
individuals to one or more listed chemicals.
By law, a warning must be given for listed chemicals unless the is low enough to pose
no significant risk of or is significantly below levels observed to cause birth defects or
other .
Where can I get more information on Proposition 65?
If you have specific questions on the administration or implementation of Proposition 65, you
can contact OEHHA's Proposition 65 program at , or by phone at
(916) 445-6900.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13

Noble House 305109 Operating instructions

Brand
Noble House
Model
305109
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents