Wincor Nixdorf K-two Installation guide

K-two

Installation manual

September 2019

01750299889C

Copyright

All rights, including rights of translation, reproduction by printing, copying or similar methods,

in part or in whole, are reserved.

the grant of a patent or the registration of a utility model. Subject to availability and technical

modifications. All names of hardware and software products mentioned in this manual are

trade names and/or trademarks of their respective manufactures.

Contents

1 Symbols .......................................................................................................................... 1

2 Warranty ......................................................................................................................... 2

3 Important Notes .............................................................................................................. 3

3.1 Connecting Peripherals ..................................................................................... 4

4 Unpacking and Checking the System.............................................................................. 5

4.1 Serial number .................................................................................................... 5

5 Overview ......................................................................................................................... 6

5.1 Exterior view...................................................................................................... 6

5.2 Interior view ....................................................................................................... 7

6 Opening the Kiosk........................................................................................................... 8

6.1 Opening ............................................................................................................ 8

7 Dimensions ..................................................................................................................... 9

7.1 Base Plate ......................................................................................................... 9

7.2 Double-Sided Kiosk (for all display sizes) .........................................................10

7.2.1 Service Area.....................................................................................................10

7.3 Single-Sided Kiosk ...........................................................................................11

7.3.1 Service Area.....................................................................................................11

7.4 Side View Single and Double Sided (for all display sizes) ...............................12

7.5 K-two with 22”-display ......................................................................................13

7.5.1 On standard and ADA stand .............................................................................13

7.6 K-two with 27”-display ......................................................................................14

7.6.1 On low and high pedestal .................................................................................14

7.7 K-two with 32”-display ......................................................................................15

7.7.1 Standard ..........................................................................................................15

7.7.2 Short ................................................................................................................16

7.7.3 Pole ADA .........................................................................................................17

8 Assembling: Wall Mounted Kiosk ...................................................................................18

8.1 Recommendation for wall mounting .................................................................18

8.2 Installation Kits and Dimensions .......................................................................20

8.2.1 Wall mounting bracket 22”: ...............................................................................20

8.2.2 Wall mounting bracket 27”: ...............................................................................21

8.2.3 Wall mounting bracket 32”: ...............................................................................22

8.3 Installation ........................................................................................................23

9 Assembling: Pole-Mounted Kiosk ...................................................................................27

9.1 Recommendation for floor mounting .................................................................27

9.2 Kiosk with Floor Cabling ...................................................................................29

9.3 Kiosk with Over-Floor Cabling ..........................................................................33

9.4 Kiosk with Ceiling Cabling ................................................................................37

9.5 Attach Cable Duct ............................................................................................39

10 Customer-specific mounting of the K-two system ..........................................................42

10.1 Important notes ................................................................................................42

10.2 Dimensions for mounting the K-two system ......................................................43

11 Pole light (K-two 32” only) ..............................................................................................44

12 EFT (Electronic-Funds-Transfer)-Terminal .....................................................................46

13 MX915 ...........................................................................................................................50

14 Ingenico IUP/IUR 250/IUC 150 ......................................................................................52

14.1 Installation ........................................................................................................53

15 Pin Pad UX 100/200/300................................................................................................56

15.1 Installation ........................................................................................................57

16 CCV C60 .......................................................................................................................61

16.1 Installation ........................................................................................................62

17 ICT 220/250 ...................................................................................................................66

18 Spire SpP30...................................................................................................................69

18.1.1 Cabling .............................................................................................................72

19 Yomani EFT ...................................................................................................................74

20 Valina.............................................................................................................................76

21 Start up the System .......................................................................................................77

22 Disconnecting the System from the Mains .....................................................................78

23 Permanent connection (USA/Canada) ...........................................................................79

23.1 Connection line ................................................................................................79

23.2 Wiring from above ............................................................................................79

23.3 Wiring from below ............................................................................................82

24 Permanent connection (USA/Canada) ...........................................................................85

24.1 Installation with metal sheath ...........................................................................85

25 Permanent connection ...................................................................................................88

26 Block diagram ................................................................................................................90

27 Technical data ...............................................................................................................91

27.1 System .............................................................................................................91

27.2 Environmental requirements .............................................................................92

27.3 Device conditions .............................................................................................93

27.4 Noise emission in acc. With EN 27779 .............................................................93

27.5 ACO Kiosk PC ..................................................................................................93

27.6 Display 22” (TEM-22F-PUG-15-C) Display 27“ (TEF-27F-PUK-15A- C)

Display 32” (TDS-32C-PUK-15A-C) ...............................................................................94

27.7 TH230+ ............................................................................................................95

28 Certifications of the Manufacturer ..................................................................................97

29 Recycling the Kiosk ........................................................................................................98

1

1 Symbols

DANGER

This warning note describes a hazard with a high degree of risk, which, if

not avoided, will result in death or grave bodily injury.

WARNING

This warning note describes a hazard with a medium degree of risk,

which, if not avoided, will result in death or grave bodily injury.

CAUTION

This warning note describes a hazard with a low degree of risk, which, if not

avoided, will result in death or grave bodily injury.

NOTICE

This note provides application tips and information that help prevent errors

and material damage.

2

2 Warranty

Generally Diebold Nixdorf guarantees a warranty engagement for 12 months beginning with

the date of delivery. This warranty engagement covers all damages which occur despite a

normal use of the product.

Damages because of

• improper or insufficient maintenance,

• improper use of the product or unauthorized modifications of the product,

• inadequate location or surroundings

will not be covered by the warranty.

For further information on the stipulation consult your contract.

All parts of the product which are subject to wear and tear are not included in the warranty

engagement. For detailed warranty arrangements please consult your contract documents.

NOTICE

Please contact your local service provider for all questions concerning your

service contract.

3

3 Important Notes

Terminals supplied by Diebold Nixdorf comply with the respective safety regulations for data-

processing installations and information technology installations, including electrical office

equipment for use within an office environment.

WARNING

Whenever work of any kind is done on the device, as well as when data

cables are plugged and unplugged, the device must be completely dis-

connected from the line voltage.

• Terminals may only be installed and repaired by skilled technicians.

• Unauthorized opening of the housing or inexpert repairs can result not only in considera-

ble personal danger, but will also invalidate your warranty and liability protection.

• Always consult the enclosed documentation before doing any work with this terminal.

• If this terminal is brought from a cold environment into a heated place of business, con-

densation may occur. Before operation, the terminal must be completely dry. Therefore,

an acclimatization period of at least two hours must be adhered too.

• Always lay the supply leads and cables in such a way that they cannot be stepped on or

tripped over.

• Exchange damaged cables immediately.

• In order to completely disconnect the terminal from the power source use the separator in

the fuse box\building installation.

• Make sure that no objects (such as paper clips) can reach the interior of the terminal,

since electrical shocks or short-circuits could result.

• Ensure that the K-two receives adequate ventilation to avoid overheating.

• During an electrical storm, data cables should not be plugged in or being unplugged.

• Keep the terminal away from vibrations, dust, humidity and heat.

• Ensure that used parts are disposed of in an environmentally friendly manner.

• In case of an accident (such as a damaged housing, entry of liquids or foreign objects),

switch the terminal off and use the separator to completely remove the terminal from

power.

• The terminal and other information technology hardware should only be connected to

electrical supply networks with a separate protective earth wire (PE). This type of electri-

cal supply network is referred to as a TN-S network. Do not use PEN conductors. Also

follow the recommendations set forth in DIN VDE 0100 Part 540, Appendix C2 as well as

EN50174-2, §5.4.3 (www.DIN.de). This will help prevent malfunctions.

4

• National Electrical Code ANSI/NFPA 70

• Canadian Electrical Code, Part I, CSA C22.1-02

• Always keep the ventilation slots free of obstruction to ensure adequate air circulation

and avoid overheating.

• Transport the terminal only in its original packaging (to protect it against knocks and

bumps).

• If a lithium battery is supplied with the terminal, ensure that the battery is replaced with an

equivalent type. Otherwise there is danger of explosion! Lithium batteries may only be

replaced with identical types or other types recommended by the manufacturer.

• Batteries must be disposed of according to local regulations on the disposal of special

waste.

3.1 Connecting Peripherals

Use only shielded cables when connecting terminals to the system to ensure compliance

with international Rules and Regulations for radiated emission as well as to achieve a high

immunity against external disturbances.

5

4 Unpacking and Checking the System

Take the system out of the package.

Verify that the scope of delivery is identical to the information on the delivery ticket.

Should you notice any

• transport damages or

• discrepancies between package contents and delivery ticket or

• functional defects,

please inform your contracting parties or the branch office of Diebold Nixdorf immediately.

Please indicate the number of your delivery ticket and delivery ticket position and serial

number of the respective devices.

NOTICE

We recommend to save the original packaging for transport at a later time

(protection from impact and shock).

4.1 Serial number

You will find the serial number on the label, which is attached underneath the housing.

6

5 Overview

5.1 Exterior view

1 Pole Light

5

Lock

2 Display

6

Scanner

3 Printer

7

EFT*

4 ADA Navigation

* It may be connected ETFs with 12Vdc and a max. current consumption of 1.1A (perma-

nent).

1

3

2

4

5

6

7

5.2 Interior view

1 Pole Light 6 ADA Navigation 11 Power Distributor

2 Display 7 NFC Module 12 Power Supply

3 Lock 8 Scanner 13 PC

4 EFT* 9 Printer

5 Speaker 10 Fan

* It may be connected ETFs with 12Vdc and a max. current consumption of 1.1A (perma-

nent).

1

3

2

4

5

10

6

7

8

9

11

13

12

8

6 Opening the Kiosk

6.1 Opening

Plug the key to the lock and turn it counter clockwise.

Open the door.

9

7 Dimensions

7.1 Base Plate

10

7.2 Double-Sided Kiosk (for all display sizes)

7.2.1 Service Area

11

7.3 Single-Sided Kiosk

7.3.1 Service Area

12

7.4 Side View Single and Double Sided (for all display

sizes)

13

7.5 K-two with 22”-display

7.5.1 On standard and ADA stand

K2 shown with standard kit for ceiling cabling, it can be enlarged up to two times with

1.151mm expansion kits.

14

7.6 K-two with 27”-display

7.6.1 On low and high pedestal

K2 shown with standard kit for ceiling cabling, it can be enlarged up to two times with

1.151mm expansion kits.

15

7.7 K-two with 32”-display

7.7.1 Standard

Page is loading ...

Wincor Nixdorf K-two Installation guide

Wincor Nixdorf K-two Installation guide

Related papers

Other documents