Amperes VP7501 User manual

Brand
Amperes
Model
VP7501
Category
Patch panels
Type
User manual
Amperes Electronics reserves the rights to change the above specifications without prior notice. All rights reserved.
INSTRUCTION MANUAL
Thank you for selecting Amperes VP7501 in your public address installation.
VP7501 has been designed to function as patch in panel to isolate the local speaker from
the main pa system. This shall allow a portable pa amplifier to be used in a specified area
using the installed speakers ( be it ceiling or box ) without additional units, thus saving the
cost in sound reinforcement setup.
Without sidelining the emergency situation requirement, each of VP7501 comes with built
in emergency overriding relay, thereby emergency paging signal from main system would
be given priority if warranted. Visual LED indicator would be available if this situation occurs,
thus making it different from other patch in panel.
INTRODUCTION
www.ampereselectronics.com
CONNECTION
Power rating
Overriding voltage
Overriding current
Patch connection
Cabling connectors
Cablings
Colour
Back box dimensions
Weight
50 watts / 100V line
24V DC
15 mA
1/4" phone jack
Pin and detachable plug
4 wire system
(2 audio and 2 overriding signal)
White ( ABS plate )
Anodised aluminum ( AL plate )
77 x 77 x 50 mm (ABS plate)
58 x 100 x 50 mm ( AL plate )
200 gms
TM
VP7501
LOCAL PATCH IN PANEL
-24V
OVERRIDING
SIGNAL
24V DC
-VE
+VE
VP7501
CONNECTORS
LOCAL PATCH IN
(OPTIONAL)
VOLUME CONTROLLERS
AMPERES VC
SPEAKER VIA
MATCHING TRANS
POWER
AMPLIFIER
70/100 V OUT
+
-
+IN
-IN
-SP
+24V
+SP
+
-
MIXER AMPLIFIER
70/100 V LINE OUT
/PORTABLE AMPLIFIER WITH
OUTPUT OF AMP. CONNECTED
TO PATCH PANEL USING
1/4" MONO JACK
70/100v
COMMON
TO AMPLIFIER
1/4" MONO JACK CONNECTION
SPECIFICATIONS
NOTE :
1. It is recommended to connect VP7501 before any volume controllers
2. The volume control shown above is an option to installation
3. Overriding LED indicator shall lit when 24V DC emergency signal is present, thereby local amplification is bypassed.
4. Do not terminate wrongly the DC voltage and amplifier signal as this may cause damage to your amplifier set as well
as the patch in panel.
  • Page 1 1

Amperes VP7501 User manual

Brand
Amperes
Model
VP7501
Category
Patch panels
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents