HiB Genesis Fitting Instructions

Brand: HiB

Model: Genesis

Type: Fitting Instructions

Fitting Instructions

Thank you for purchasing this HiB Novum product.

Please read through these instructions carefully and refer back to

them during installation to ensure that your product is ﬁtted safely

and that it retains its high quality ﬁnish.

GENESIS FITTED FURNITURE - DRAWERS

Top Drawer: Art No. NF02S3DRT30***

Lower Drawer (mid or bottom): Art No. NF02S3DRL30***

MBL - Midnight Blue | DEM - Dark Emerald | CGR - Carbon Grey |

MWH - Matt White | SWO - Sherwood Oak

FI#03 022 R220426 Ver 1.0 June 2022

• Please read the instructions and warnings carefully before

installing the product and ensure this document is kept with the

product for future reference, to ensure product longevity and in

the interest of safety.

• This product is intended for domestic use only.

• Not for use in saunas or steam rooms.

• Do not overload shelves or unit.

• Do not sit or stand on the unit.

• Ensure that excessive standing and surface water is removed

from the product to avoid long term damage and spoiling.

Warnings for Safe Use

Tools Required

Screwdriver

Drawer Installation and Adjustment

1. HiB recommends ﬁxing handles to the drawer box prior to installing the

drawers.

2. Align the drawer onto the runners ensuring the rear hooks are located in the

holes on the rear of the drawer box, see Fig. 1.

3. Ensure that the locator pin on the front of the runner, see Fig. 2, is aligned with

the hole predrilled on the base of the drawer.

4. Push the drawer shut to check the alignment of the drawer. Adjust using the

adjustment wheel on the drawer runner, see Fig. 17.

5. If additional adjustment is required locate the central screw behind the drawer

front in the drawer box. Loosen the screw, adjust the drawer front into position

and then tighten the screw, see Fig. 18.

6. Push the drawer shut to ﬁnish.

Figures

Fig. 1 - Drawer Runner Rear Hooks Fig. 2 - Locator Pin & Adjustment Wheel

Fig. 3 - Drawer Front Adjustment

Locator Pin

Adjustment Wheel

1. Loosen screw

2. Adjust drawer front

3. Tighten screw

Care & Maintenance

Aftercare

Replacement components can be purchased from your retailer, quote the

article number found on the Care & Maintenance label located on your furniture

component. See example below:

In the unlikely event that this product should fail please contact the retailer from

which the item was purchased.

To preserve the high quality ﬁnish of your HiB product, please ensure you regard

the following care and cleaning recommendations:

• Use only a so damp cloth.

• Wipe oﬀ all water spillages as soon as possible.

• Do not use any abrasives or solvents.

• Ensure adequate ventilation is maintained in the bathroom.

CARE & MAINTENANCE

All cut edges must be sealed

Clean with a so, damp cloth

Do not use any abrasives or solvents

Ensure that excessive standing and surface

water is removed from the product to

avoid long term damage and spoiling

Scan for

information

Article No.: Batch No.:

NF02TP50CGR

©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try

and make sure they are as accurate as possible. In the interest of continuous product development, HiB reserves the right to alter speciﬁcations as necessary.

E & OE.

T: +44 (0)20 8441 0352 F: +44 (0)20 8441 0219 E: [email protected].uk hib.co.uk

Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN