HiB Genesis Fitting Instructions

Brand
HiB
Model
Genesis
Type
Fitting Instructions
Fitting Instructions
Thank you for purchasing this HiB Novum product.
Please read through these instructions carefully and refer back to
them during installation to ensure that your product is fitted safely
and that it retains its high quality finish.
GENESIS FITTED FURNITURE - DOORS
Double Doors: Art No. NF02DD50*** / NF02DD60***
Single Door Unit: Art No. NF02SD30***
MBL - Midnight Blue | DEM - Dark Emerald | CGR - Carbon Grey |
MWH - Matt White | SWO - Sherwood Oak
FI#03 021 R220426 Ver 1.0 June 2022
• Please read the instructions and warnings carefully before
installing the product and ensure this document is kept with the
product for future reference, to ensure product longevity and in
the interest of safety.
• This product is intended for domestic use only.
• Not for use in saunas or steam rooms.
• It is recommended that this product is installed by 2 people who
are able to meet the level of competence required in order to
comply with relevant regulations.
• When drilling and cutting use appropriate eye protection and
wear an appropriate dust mask.
• Take care when using power tools near water - the use of a
residual current device (RCD) is advised.
• Ensure that excessive standing and surface water is removed
from the product to avoid long term damage and spoiling.
Warnings for Safe Use
Tools Required
Screwdriver
Door Installation and Adjustment
1. Release the hinge plate from hinges, see Fig. 1.
2. Push the hinge plate into the pre-drilled holes provided and secure into place
using the screws provided. HiB advises against using an impact driver. When
installing a single door unit, take note of the le hand / right hand orientation
prior to installation.
3. Reattach the hinges to the hinge plates.
4. Adjust the hinges as required, see Fig. 2.
Fig. 1 - Release hinge plate
Fig. 2 - Door Adjustment
Move door(s) up/down
Move door away/towards
the cabinet
Move door(s) le/right
Move door(s) up/down
Move door away/towards
the cabinet
Move door(s) le/right
Figures
Care & Maintenance
Aftercare
Replacement components can be purchased from your retailer, quote the
article number found on the Care & Maintenance label located on your furniture
component. See example below:
In the unlikely event that this product should fail please contact the retailer from
which the item was purchased.
To preserve the high quality finish of your HiB product, please ensure you regard
the following care and cleaning recommendations:
• Use only a so damp cloth.
• Wipe off all water spillages as soon as possible.
• Do not use any abrasives or solvents.
• Ensure adequate ventilation is maintained in the bathroom.
CARE & MAINTENANCE
All cut edges must be sealed
Clean with a so, damp cloth
Do not use any abrasives or solvents
Ensure that excessive standing and surface
water is removed from the product to
avoid long term damage and spoiling
Scan for
more
information
Article No.: Batch No.:
NF02TP50CGR
©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try
and make sure they are as accurate as possible. In the interest of continuous product development, HiB reserves the right to alter specifications as necessary.
E & OE.
T: +44 (0)20 8441 0352 F: +44 (0)20 8441 0219 E: [email protected].uk hib.co.uk
Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

HiB Genesis Fitting Instructions

Brand
HiB
Model
Genesis
Type
Fitting Instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents