2. KarliK
  3. MCUSB-6
MCUSB-6

KarliK MCUSB-6 User manual

  • Hello! I've reviewed the user manual for the Karlik MCUSB-6 double USB charger. This document provides details about its specifications, including dual USB ports and a total output current of 3.1A. It also includes assembly instruction and some warranty information. I'm ready to answer any questions you have about the charger or the information contained in the manual.
  • What kind of devices can be charged using this charger?
    What is the total nominal output current of the charger?
    What is the warranty period for this product?
USER MANUAL -MCUSB-6
DOUBLE USB CHARGER
Specification of MCUSB-6 double USB charger
The MCUSB-6 charger is intended to charge devices like smartphones, MP3 players and other
electronic equipment. Before connecting the device, check compliance of the charger with
charging parameters of the given device.
1 I 2
Warranty conditions
Warranty is granted for a period of 12 months of the date of purchase. The defective DCUSB-6 charger
along with the proof of purchase should be sent to the manufacturer or to the seller. Warranty does not
include mechanical damages, defects resulting from unauthorised repairs and improper use of the
product.
Warranty period will be extended for the duration of the repair.
Number of USB ports (type A)
2
Nominal input voltage
100-240V AC; 50/60Hz
Nominal input current
0,25 A
Nominal output voltage
5 V DC
Nominal output current
3.1 A ( )total value for the whole mechanism
Ingress protection degree
IP 20
Dane techniczne
54,00
54,00
41,00
ASSEMBLY INSTRUCTIONS
2 I 2
USB charger mechanism with idle power supply consumes less than about 0,2W.
The connection to the installation should be done as shown in Figure 2. With improper connection, the
charger may be damaged or may work incorrectly.
The installation must be done by a person with sufficient qualifications, with power supply
disconnected, and must comply with national safety standards.
NOTE!
3. Dismantle the USB charger modules (4).
6. Insert the spacer frame in the external frame (6) and snap the entire set on the tabs protruding from
2. Remove the screw (2).
the assembly block.
5. Set the assembly block in the box (9) with tabs or screws at the box (8).
9. Screw down the intermediary unit to the assembly block.
4. Remove the spacer frame (5) from the assembly block (7). Pull away the block tabs or pull the frame
10. Attach the label and glass pane.
1. Remove the glass panel (1) with the label applying a knife or a flat screwdriver in the recess (3).
7. Connect the wires of the installation to the USB charger module as shown in Figure 2.
tightly to do this.
8. Insert the USB charger modules in the intermediary unit.
Fig. 1
9
8
76
5
4
2
3
1
Fig. 2
/