KarliK ICUSB-1 User manual

Brand: KarliK

Model: ICUSB-1

Type: User manual

KarliK ICUSB-1 is a single USB charger designed to charge electronic devices like smartphones and MP3 players. It features a nominal input voltage of 110-240V~, a nominal input current of 0.25A, a nominal output voltage of 5V DC, and a nominal output current of 1A/2A. The device boasts an ingress protection degree of IP 20, ensuring protection against solid objects like dust and fingers. Additionally, it comes with a 12-month warranty, further assuring its reliability and performance.

USER MANUAL: ICUSB-1 / ICUSB-3

SINGLE USB CHARGER

Specification of ICUSB-1 / ICUSB-3 single USB charger

The ICUSB-1 / ICUSB-3 charger is intended to charge devices like smartphones, MP3 players and other

electronic equipment. Before connecting the device, check compliance of the charger with

charging parameters of the given device.

1 I 2

Warranty period will be extended for the duration of the repair.

Warranty is granted for a period of 12 months of the date of purchase. The defective ICUSB-1 /ICUSB-3

charger along with the proof of purchase should be sent to the manufacturer or to the seller. Warranty

does not include mechanical damages, defects resulting from unauthorised repairs and improper use

of the product.

Warranty conditions

Number of USB ports (type A))

Nominal input voltage

110-240 V~ 50/60Hz

Nominal input current

0,25 A

Nominal output voltage

5 V DC

Nominal output current

1 A / 2 A

Ingress protection degree

IP 20

Specification

54,00

41,00

ASSEMBLY INSTRUCTIONS

2 I 2

The connection to the installation should be done as shown in Figure 2. With improper connection, the

charger may be damaged or may work incorrectly.

USB charger mechanism with idle power supply consumes less than about 0,2W.

The installation must be done by a person with sufficient qualifications, with power supply

disconnected, and must comply with national safety standards.

NOTE!

1. Remove the glass panel (1) with the label applying a knife or a flat screwdriver in the recess (3).

2. Remove the screw (2).

8. Insert the USB charger module in the intermediary unit.

7. Connect the wires of the installation to the USB charger module as shown in Figure 2.

3. Dismantle the USB charger module (4).

6. Insert the spacer frame in the external frame (6) and snap the entire set on the tabs protruding from

the assembly block.

9. Screw down the intermediary unit to the assembly block.

4. Remove the spacer frame (5) from the assembly block (7). Pull away the block tabs or pull the frame

tightly to do this.

5. Set the assembly block in the box (9) with tabs or screws at the box (8).

10. Attach the label and glass pane.

Fig. 2

Fig. 1

KarliK ICUSB-1 User manual

KarliK ICUSB-1 User manual

KarliK ICUSB-1 User manual

Related papers

Other documents