Page is loading ...
28mm Wild West Ranch House
B28-OW-101
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Take the main base (A) and the four internal
walls (L, G, P and O). Glue them together as
shown above with their detail facing into the
building. Holes in the base will match the lugs on
the bottom of each piece.
Then take the four external walls (F, M, H and Q). Glue
these to the inner walls as shown above.
Next, remove the side room base (B) and parts N,
U1 and U2 from the sprue. Glue these together
as shown will all the detail facing into the room.
Glue the external pieces (R, V1 and V2) to the outside
of the side room as shown. The attach the whole
assembly to the side of the main room using the
lugs/holes provided.
The base of the porch (E) slots into the holes
provided, then add end supports (J1 and J2) as
shown.
Glue a doorframe (C) to the inside and outside of each
doorway – and a windowsill (I) under each window.
Door supports (K) should be glued to the back of
each door (D).
Glue each pair of roof pieces (S) and (T) back to back.
Glue these to the roof, so that the holes in each
corner are on the inside of the roof.
Glue the doors into position. The porch roof (X) and
side roof (Y) can be left unglued, so they can be easily
removed to access figures during use.
/
