WJFS616

Panasonic WJFS616 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Panasonic WJFS616 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Installing the WV-PB6164
Data Multiplex Boards
Caution: Before installing boards be
sure to turn off the Power Switch of
the WJ-FS616 video multiplexer.
1. Remove the six screws on the top cover
of the WJ-FS616 video multiplexer as
shown at right.
2. Remove the top cover.
3. Remove the four screws on the board as
shown at right..
4. Remove the one screw shown at right.
Then turn over the printed circuit board
with the front side up.
Data Multiplex Board WV-PB6164
The installation described below should be made by qualified service personnel or system
installers.
Front
Rear
5. Pull out the two knobs on the bracket
shown at right. Then remove that brack-
et.
6. Set the jumper connector, located at the
top left of the board to be installed, to the
position shown at right.
Board Connector
Board Connector
7. Insert the board and confirm that the
position is correct. Then push it in
straight.
8. After installing the boards, secure them
by tightening the screws and knobs
shown above.
Note: Refer to the WJ-FS616 Operating
Instructions for further details. VD2
and data settings are required on
the SET UP MENU of the Video
Multiplexer.
Initial State Installed State
2
1
8
7
2
1
8
7
N0797-0 YWV8QA4699AN Printed in Japan
N 19
Jumper Connector
1/2