Adventuridge 4 Person Air Tent User manual

Brand: Adventuridge

Model: 4 Person Air Tent

Type: User manual

The Adventuridge 4 Person Air Tent is a spacious and versatile tent designed for comfortable camping trips. With its easy air inflation system, you can set up your tent quickly and effortlessly, making it ideal for spontaneous getaways or extended camping adventures. The tent features a durable polyester construction, ensuring longevity and protection from the elements. It includes a separate inner tent for added privacy and a storage wall for organizing your gear. The tent also comes equipped with guy ropes and steel pegs for secure anchoring, ensuring stability even in windy conditions.

4 PERSON AIR TENT

INSTRUCTIONS

MANUAL

v20718

IRE

IMPORTANT INFORMATION

CAUTION: READ ALL INSTRUCTIONS BEFORE USE TO ENSURE CORRECT SETUP.

DO NOT OVER INFLATE. USE A SUITABLE PUMP TO INFLATE. INFLATE TO 7PSI MAXIMUM.

Please read these instructions carefully before attempting to set up your tent and retain

for future reference. If used properly, your tent should provide years of trouble free use.

This tent contains a high proportion of synthetic materials and under certain conditions

will be aected by condensation inside the tent. This should not be confused with leaking.

Condensation can be improved by ensuring adequate ventilation.

This tent is designed for use in light to moderate weather. During strong winds or snowfall

we recommend that you take your tent down. The tent is designed for touring use; it is not

designed for static or commercial use.

We recommend a trial run before setting up your tent for the rst time. This will allow you

to familiarise yourself with the tent, its set up and any limitations the tent may have for

your particular use.

AIR PUMP (not included)

We recommend a single action hand

pump with a pressure gauge. This air

tent will require air pressure of 7PSI.

The valve adapter (Boston valve) will

normally be supplied with the pump.

CHOOSING A SITE

Choose a site that is at and, if possible, protected from the wind. Try to clear

the site of sharp stones to avoid damaging the groundsheet. Avoid pitching

under trees as falling branches, sap, etc could damage your tent.

BEFORE USING YOUR TENT

PLEASE CHECK THE CONTENTS

TENT SIZE: (W x D x H)

260cm x 485cm x 190cm

INNER TENT SIZE: (W x D x H)

240cm x 240cm x 175cm

ITEM QTY

Outer tent 1

Inner tent 1

Fiberglass pole 1

Storage wall 1

Ground pegs 21

Guy ropes 11

Storage bag 1

Example of a single

action hand pump

with pressure gauge.

Boston valve

adapter

(not included)

(D) 485cm

(W) 260cm

(H) 190cm

SETUP

Unpack the tent from the storage bag and identify each part.

STEP 1

Unroll and lay the outer tent out in the required position. Peg each anchor

point (1) of the groundsheet (there are 10 in total). Ensure that you tension the

groundsheet between the pegs to keep shape. You may need to re-peg later.

Inate valve - this valve is used to inate the air poles.

Deate valve - this valve deate the air poles.

Air tube valve - this valve provides an air tight connection between the valve

unit and the air pole. NOTE: the air tube valve should always be kept fastened.

AIR VALVES

There are 3 ination valves on this tent. Each valve has 3 parts (2). All valves are

clockwise to tighten and anti-clockwise to loosen.

Pegs should be driven into the

ground at a 45°angle away from

the pegging point.

(1)

(2)

Air tube valve

Inate valve

Deate valve

(3)

Back valve

Center valve

Front valve

Insert the pump nozzle

rmly before pumping

Front door

(3a)

(4)

Centre

air pole inated

Centre and back

air poles inated

Centre, back and front

air poles inated

Step 2

Locate the center ination valve (3). Unscrew the inate valve cap and attach

pump nozzle (3a). Start to pump. As the air pole inates the tent will begin to

take shape (4). It may be necessary help push up the pole so it can easily assume

the correct shape.

Inate the air pole until it feels hard to the touch. The maximum air pressure

is 7 PSI. It does not matter if you do not reach this, as long as the air pole feels

hard to the touch.

Once the air pole is inated remove the pump nozzle, the air will not escape as

this is a one way valve. Close the inate valve cap. Repeat for back air pole and

front air pole.

Check the positioning of the groundsheet pegs again. If necessary re-peg to

ensure that the groundsheet is taut inside the tent.

Step 3

Assemble the berglass porch pole, this is shock corded and just needs slotting

together. Ensure that each pole is fully inserted into the adjoining pole.

Slide the porch pole into the sleeve at the leading edge of the porch. Each end

of the pole t into the pockets on either side (5).

Step 4

Connect the inner tent as shown below using hook and toggle fasteners.

Start at the rear points and work your way towards the front (6).

Connect the storage wall using hook and pre attached ring fasteners (6).

Porch pole sleeve

Porch pole pocket

(5)

(6)

= Hook

= Toggle

Rear points

Inner

tent

Storage

wall

Step 5

We recommend that guy ropes be used at all times. Attach guy ropes to each

anchor point on the outer tent canopy (7).

IN USE CARE INSTRUCTIONS

This tent is designed for use in light to moderate weather. During very strong

winds or snowfall we recommend that you take your tent down. The tent is

designed for occasional use; it is not designed for static or commercial use.

Tent fabrics can be weakened by prolonged exposure to sunlight. Under normal

holiday use your tent will give long service but use for extended periods in

strong sunlight will soon cause deterioration. In those cases it would be wise to

use a site as shaded as possible.

Peg the guy lines so that the tent is under tension without distorting the shape.

The guy lines can be adjusted using the runners. Guy lines should be secured

using suitable pegs and the guy line should generally be pegged in line with the

seam of the anchor point it starts from. Check the guy lines from time to time to

ensure that they are adequately tensioned.

This tent is supplied with general purpose steel pegs. These are suitable for many

sites but there will be some instances where dierent pegs may be necessary.

For maximum eectiveness, pegs should be driven into the ground at a 45°angle

away from the pegging point.

(7)

Front door

SAFETY

DO NOT COOK IN THE TENT OR USE NAKED FLAMES. READ AND

UNDERSTAND THE FIRE PRECAUTIONS LABEL SEWN INTO THE

INSIDE OF THE TENT.

PACK DOWN

1. Remove the inner tent and storage wall.

2. Un-peg the guy lines and tie them neatly to avoid future tangling.

3. Deate the air poles by loosening the deate valve (2) one each pole. The tent

will start to deate.

4. Un-peg the groundsheet.

5. Fold/roll the tent towards the deation valves to expel more air and then roll

to t in the carry bag.

6. Ensure that the tent is totally dry before storing in a cool, dry space.

CARE: Wipe clean with a damp cloth. Allow to dry before storing. To prevent

mould and mildew, ALWAYS ensure the tent is completely dry before storing.

DO NOT fold or store when wet or damp. ALWAYS store in a well-ventilated area.

This tent conforms to the requirements of ISO5912.

This performance level 1 tent is designed for short term use.

MATERIALS: Polyester, berglass pole, guy ropes and steel pegs.

Zipped doors, Polyurethane oor, PVC windows and mesh windows.

FIRE AND SAFETY PRECAUTIONS:

WARNING: KEEP ALL FLAME AND HEAT

SOURCES AWAY FROM THIS TENT FABRIC.

EXTREME CAUTION: NEVER USE ANY FUEL

BURNING OXYGEN CONSUMING DEVICES

OR ANY DEVICES THAT PRODUCE ANY FUMES,

INCLUDING STOVES, LANTERNS, CANDLES OR

HEATERS IN OR AROUND YOUR TENT. THIS

COULD RESULT IN CARBON MONOXIDE

POISONING, INJURY AND/OR DEATH.

ALWAYS ENSURE TENT IS FIRMLY SECURED TO

GROUND BEFORE USE.

TENT IS DESIGNED FOR TEMPORARY USE ONLY

AND NOT AS A PERMANENT STRUCTURE.

DO NOT SMOKE IN TENT.

FIRE AND VENTILATION PRECAUTIONS

CAUTION:

DO NOT USE GAS OR OTHER

COMBUSTION APPLIANCES.

DO NOT PLACE HOT APPLIANCES NEAR THE

WALLS, ROOF OR CURTAINS.

ALWAYS OBSERVE THE SAFETY INSTRUCTIONS

FOR THESE APPLIANCES.

NEVER ALLOW CHILDREN TO PLAY NEAR HOT

APPLIANCES.

KEEP EXITS CLEAR.

MAKE SURE YOU KNOW THE FIRE PRECAUTION

ARRANGEMENTS ON THE SITE.

MAKE SURE VENTILATION OPENINGS ARE OPEN

ALL THE TIME TO AVOID SUFFOCATION.

4 PERSON AIR TENT

INSTRUCTIONS

MANUAL

v20718

IRE

Adventuridge 4 Person Air Tent User manual

Adventuridge 4 Person Air Tent User manual

Adventuridge 4 Person Air Tent User manual

Related papers

Other documents