2. Computers & electronics
  3. TVs & monitors
  4. Flat panel wall mounts
  5. Atdec
  6. VF-WD
VF-WD

Atdec VF-WD Specification

  • Hello! I am an AI chatbot trained to assist you with the Atdec VF-WD Specification. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Component Checklist
Component Checklist
Component Checklist
Component Checklist
Disassemble
Step 1
Using the supplied
Allen Key, remove
the bottom screw.
Installation Instructions
IMPORTANT: Ensure you have received all parts
against the component checklist prior to installing.
Bits Bag
5mm Allen Key
Wall Plug (x2)
50mm Screw (x2)
Mounting Fasteners
M4x10mm Screw (x4)
M4x12mm Screw (x4)
M4x16mm Screw (x4)
Visidec Focus Wall Direct
supports a maximum
weight of 8kgs (17.5lbs)
TOOLS REQUIRED:
l Power Drill
l 5.5mm (1/4”) Drill Bit
l 8mm (5/16”) Drill Bit
l Phillips Head Screwdriver
NOTE: This product is
designed to support
a flat panel monitor
in a noninteractive
environment.
i.e. It should not be
used in a situation
where the display’s
position will be
frequently changed.
A
Step 2
Separate the two
components.
Wall Direct Assembly
Attach Base to Wall
Masonry Wall
B
Timber Stud Wall
OR
Wall Plug
8mm (5/16”) hole
50mm Screw
Tip: Use a Spirit Level
to ensure this surface
is horizontal.
5.5mm (1/4”) hole
Timber
Stud
50mm Screw
Tip: Use a Spirit Level
to ensure this surface
is horizontal.
Attach Head to Display
D
Attach Display to Wall
E
Adjust Display Position
F
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 18.01.08 ©
OR
Step 1
Position the
Display & Bracket
over the Base.
Step 2
Close the two halves of the Bracket
around the Base by firstly positioning
the top half and then the bottom half.
Step 3
Reassemble the Wall Direct Assembly
ensuring the weight of the display is
supported until the screw is tightened.
Tip: This step can be made
easier by using two people.
WARNING:
Do not
overtighten.
Step 1
Adjust the display to
the desired viewing
angle then lock it in
place by tightening
the tilt screw in the
direction shown.
Step 2
Adjust the display’s
position between
landscape and portrait.
The display can rotate
through +/-95º.
WARNING:
Do not
overtighten.
NOTE:
Screen does not
rotate 360°
Tighten
+/-95º
1
2
75x75mm VESA 100x100mm VESA
75mm
(3”)
75mm
(3”)
M4 screw
M4 screw
100mm
(4”)
100mm
(4”)
/