3
ACW125
ACW250
ACW400
ACW800
4
Please read and follow this instruction before using .Shunt Trip or Under Voltage Trip
·Thisproduct must be installed and serviced by electrical qualified electrical person.
·Please install this product only to the applicable frame types.
SHUNT COIL
1. Turn off the upstream circuit breaker before installation to prevent electric shocks and burns due to short circuit.
DANGER
CAUTION
Applicable to ACW125 ACW250 ACW400 ACW800
1 2
ACW125 ACW250 ACW400 ACW800
Tripped
Push to trip
0.4~0.75mm
24-18AWG
2
7 lbf.in
(0.8N.m.)
7 lbf.in
(0.8N.m.)
7 lbf.in
(0.8N.m.)
10 lbf.in
(1.2N.m.)
10 lbf.in
(1.2N.m.)
Please operate the handle into ON position when you
remove the Shunt Trip and Undervoltage Trip device
from MCCB.
Shunt Trip
Under Voltage Trip
TheCOVERhastoassembledforthetestingofthe
ShuntTripor UndervoltageTripdevice.
Remove ribs
with plier
COVER
click
click
click
click
I MANUALNSTRUCTION
DANGER
CAUTION
It may result in death or serious injury.
It may result in injury or physical damage.
resumes when
following
. Prior to fitting these devices confirm if the circuit breaker is an applicable type.
.If there is excessive pressure to the HOOK, it can be damaged.
. Don’t operate MCCB unless Under Voltage Tripis energized.
/
