HANDLE LOCK Installation
Put handle in "OFF" position
1. The HANDLE position of ACW: "OFF" -> "ON"
2., 3., 4. : OFF LOCK (Same as OFF LOCK)
1-1) Locking at off position (ACW125)
1-2) Locking at on position (ACW125)
REMOVE TIGHTENED SCREW from
COVER assemble HANDLELOCK to COVER
using screws provided withHANDLE-LOCK
Fasten HANDLELOCK with locks
1 2
3 4
Readthemanualand warningmessageforsafetybeforeusing products.
¤
¤
Thismanualshould begiven tothepersonwho actuallyusesthe products andisresponsiblefor theirmaintenance.
Before installation, wiring, operation, maintenance and inspection of the device, read the safety precautions
carefullyandfollowthemessagetoensureproperoperations.
¤Turnoff the power before starting mounting,withdrawing,wiring,maintenanceorinspection.
Failureto do may resultin electric shocks and burns.
DANGER
CAUTION
HANDLELOCK
Fold HANDLE LOCK towards handle
1. Do notuse any deformedor damageddevice.
2.Mounting, withdrawing, maintaining andchecking should be done by an authorized or certified person.
3. It should not be used in severe environment such as high temperature, high humidity, dusty,corrosive gas,
excessive vibration and impulse.
They may result in fire or malfunction.
4.Use thedevice in a range of the rate currentand poleof MCCB.
5. Mounting should be done accordingto the instruction manual.
Failure tomount may causemalfunction of MCCB or causean incident whichmakes the operator hurt.
6.Screws should be tightened to specific torque.
8.Do not modify the device unless itis permitted.
9.When the device become useless,it shouldbe disposed as an industrial waste.’’
7. Be carefulnot to damaged by accidentsduring transportationor instalation.
DIMENSION of LOCK
0.196
~
0.315in
1.181in
INSTRUCTION MANUAL
ApplicabletoACW125 ACW , ACW ACW, 250 400, 800
DANGER
CAUTION
It may result in death or serious injury.
It may result in injury or physical damage.
1. The HANDLE position ofACW : "OFF" -> "ON"
2., 3., 4. : OFF LOCK° Same as OFF LOCK
2-1) (ACW250~ACW800)Locking at off position
Remove tightened screw from COVER,assemble HANDLE-LOCK
to COVERusing screwsprovided with HANDLE-LOCK
2-2) Locking at on position (ACW250~ACW800)
Put handle in "OFF" position
Fold HANDLE-LOCK towards handle Fasten HANDLE-LOCK with locks
1 2
43
DIMENSION of LOCK
0.196
~
0.315in
1.181in
INSTRUCTION MANUAL
7 lbf.in (0.8N.m)
10 lbf.in (1.2N.m)
10 lbf.in (1.2N.m)
ACW250
ACW400
ACW800
/
