7
Auto Mode will nd an efcient and economical way to run automatically according to the relative
humidity and temperature.
Ideal Usage: Use this mode for maximum energy saving and for quiet operation.
Quick Dry mode: The unit will operate the heater in a high working status and fan at a high speed to
dehumidify a very damp room in the rst couple of days. It is suggested to switch to “NORMAL DRY”
mode whilst the relative humidity goes down to save more energy.
Ideal usage: Use to dry clothes quickly over a short period of time or to dry a very damp room quickly.
Normal Dry mode: The machine works the heater in a low working status and fan at
“Medium” speed.
Ideal usage: Use to dry clothes over a longer period of time; this is more economical than “QUICK
DRY” mode.
Eco mode: The Heater is off and the fan will operate on a low speed to reduce the noise level, the
dehumidier will sample the air for its humidity level and will dehumidier again when relative humidity
rises.
Ideal usage: Use on a daily basis in your home to keep the humidity to a healthy level of approx.
55%RH. Bacteria and mould will not breed at this level.
• Press the “TIMER” button to select the required time from 1 Hour to 8 Hours
• The unit will automatically stop when the pre-set time has nished. You can change the selected time
if necessary. Press the “TIMER” button to change or stop the pre-set timer.
Note: After 4 hours of continuous use, the heater motor will automatically stop for 3 minutes to
ensure that the unit doesn’t overheat. The Fan will continue to run during this period.
Note: After 12 hours of continuous use, the unit will automatically switch off and the LED lights will
ash, this is normal and is designed to prevent the unit from overheating. After a short time you can
restart the unit by unplugging from the socket and then plugging back in.
• You can turn the unit off at any time by pressing the “ON/OFF” button
Note: After pressing the “ON/OFF” button to turn the unit off, the fan will continue running for 2
minutes to circulate the heat, DO NOT remove the plug until the fan has completely stopped.
• Press the “OSCIL” button to select the angle of the air ow - 90° / 45° Lower / 45° Upper
• Press the “ION” button to Start and Stop the Ioniser function, which recharges the negative ions to
purify the air.
Note: This function can only operate when the lter is installed
REMOVABLE PARTS
Install the Filter
• Pull the handle up
• Pull the lter upwards from the back
of the unit
• Place the lter into the slots and push downwards
until it locks into position, you will hear a “click” sound.
How to empty the water tank
• Underneath the water tank there is a handle.
Grip the handle and pull out the water tank completely.
• Remove the lid from the water tank
• Empty the water down a sink
• Replace the lid and push the water tank
back into position.