BLOTZ B28-SFW-101 Assembly Instructions

Brand: BLOTZ

Model: B28-SFW-101

Type: Assembly Instructions

This manual is also suitable for

28mm Sci-Fi Walls – Columns

B28-SFW-050 / 051

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place

while you allow glue to dry.

The instructions for both types of column are the same. The only difference between the kits is the number of each

different wall type you are supplied with.

The three wall types with their inner piece (left)

and outer piece (right)

(Join, Girders, Fan)

Choose the sides for your column and glue the four

inner pieces to the base as shown.

(The base and lid are the same)

Glue the lid into place.

Glue the corresponding outer pieces into place.

The corner pieces (inner to left, outer to right)

Glue the inner pieces into place.

Then add the puter pieces.

Finished Example #1

Finished Example #2

1
2

BLOTZ B28-SFW-101 Assembly Instructions

Brand: BLOTZ

Model: B28-SFW-101

Type: Assembly Instructions

This manual is also suitable for

Download PDF

Related papers

Other documents