2429 E Olympic Blvd., Los Angeles, CA 90021
800-392-7277 • 213-627-8441 • www.westbrass.com
TO CLEAN:
Do not allow your product to come into contact with any cleansers
fortified with ammonia, bleach, grease-cutters or other surfactant
chemicals. Soft Scrub, Dawn Liquid Soap, Palmolive or any other
combined cleaners contain certain chemical components that will
dissolve and remove the finish’s protective coating, and eventually
the finish itself. Use only plain warm water and mild soap on a soft
cloth or sponge. Avoid using any sponge with a scouring pad to
clean your product. It is not necessary to rub hard to remove spots.
FINISH INFORMATION:
With the exception of living finishes, all Westbrass decorative finishes are protected by the strongest finish treatments
available while maintaining their luxurious appearance. While some finishes are more durable than others, no finish is
indestructible. Polished Chrome, Satin Nickel and PVD Polished Brass finishes are the most durable. All other finishes are
electroplated; some are then coated to enhance the gloss and durability. “Living” finishes are uncoated, designed to be
exposed to the air and other elements, with the intention to age and change in their natural beauty. All of our finishes,
plated and living, require some care in use.
TO PROTECT:
An occasional application of Carnauba wax
(without cleaners), like that found in Flitz Faucet
Wax, Turtle Wax for Clear Coat Car Finishes or
McGuire’s Premium Wax, will enhance the finish
lustre, reduce hard water spots and add an extra
layer of protection to your finish.
1. Remove the compression nut, ferrule, locknut,
friction washer and base washer from the faucet.
2. Seat O-ring in base groove. If desired a thin
bead of silicone seal can be applied to the O-
ring for added sealing power. Please do not use
Plumber’s Putty.
3. Center the faucet in the mounting hole and
fasten with base washer, friction ring and mount-
ing nut. Do not over tighten.
4. Slide the 1/4” compression nut and ferrule
over the supply tubing, insert the tube in the
mounting nipple and tighten the compression
nut on the mounting nipple. Do not over tighten.
5. Fully open the handle on the pure water fau-
cet and then turn on the water supply. Allow the
water to run to rince any debris from the system.
6. Check for leaks especially at the water supply
attachments.
INSTALLATION INSTRUCTIONS:
1/4” Compression
Nut and Ferrule
7/16” - 24
4”
2-1/2”
1-3/4”
8-3/4”
10-1/2”
3/8”
5”
5-3/4”
6-1/2”
11-1/4”
3/8”
1/4” Compression
Nut and Ferrule
2-1/4”
2-1/2”
5-3/4”
7/16” - 24
3”
1-3/4”
4-3/4”
D2033 D2036
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Barclay 5577-SN Dimensions Guide
-
-
Whitehaus Collection WHFH-C2011-C Installation guide
-
BTI Aqua-Solutions C2200-BN Installation guide
-
American Standard Town Square Deck-Mount Bath Filler 2555.900 User manual
-
Gerber Hardwater Single Handle Kitchen Faucet User manual
-
Signature Hardware 318960 Installation guide
-
Franke LB12200 Installation guide
-
Signature Hardware 305571 Installation guide
-
