Ralph Lauren RL2565 User manual

Brand: Ralph Lauren

Model: RL2565

Type: User manual

Ralph Lauren RL2565 is a 24-inch linear sconce designed for both indoor and outdoor/wet locations. It features a stylish design that complements various decors. Installation requires basic tools and involves attaching the mounting plate to the junction box, connecting the wires, and securing the fixture to the mounting plates. For outdoor use, apply silicon compound to prevent water entry. Care instructions include using a soft dry cloth or feather duster, avoiding abrasive or chemical agents.

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (A & H) from fixture (E) by removing

screws (D).

3. Install mounting plate (A) to junction box and secure with mounting

screws (B).

4. Using mounting plate (H) and fixture body as a guide, mark anchor

positions.

NOTE: Carefully measure distance between mounting points for

mounting plate (H) and junction box before moving to the next step.

5. Using a drill bit slightly smaller than the anchor, drill holes in the

marked positions. Install anchors (F) into the holes using hammer.

6. Install mounting plate (H) to wall and secure with wood screws (G)

to anchors (F).

7. Wrap supply ground wire (bare copper) around the green grounding

screw. Tighten. (See diagram 1)

8. Connect fixture neutral wire (white) to the supply neutral wire

(usually white) using wire nut (C).

9. Connect fixture hot wire (black) to the supply hot wire (usually

black) using wire nut (C).

CAUTION: Do not reverse the hot and neutral connections.

Northport 24” Linear Sconce

Item # RL2565

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED):

NOTICE:

A C D EB

Phillips Screwdriver Slotted Screwdriver Drill

DF GH

Pencil Hammer

Diagram 1

Northport 24” Linear Sconce

Item # RL2565

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

10. Make sure all wire connections are tight, then carefully tuck into the

junction box.

11. Install fixture (E) to mounting plates (A & H) by securing with

screws (D).

FOR OUTDOOR/WET LOCATION INSTALLATION:

12. Using silicon compound, apply a small bead where backplate meets

the wall to prevent water from entering.

NOTE: Large gaps will need to be corrected before applying

silicon compound.

Care Instructions: Clean only with a soft dry cloth or feather duster. Do

not use abrasive or chemical agents.

NOTICE:

A C D EB

DF GH

Diagram 1

Ralph Lauren RL2565 User manual

Ralph Lauren RL2565 User manual

Ralph Lauren RL2565 User manual

Related papers

Other documents