2. Rigid
  3. 2020+ Ford Super Duty A-Pillar Mount Kit

Rigid 2020+ Ford Super Duty A-Pillar Mount Kit User manual

  • Hello! I'm here to assist you with the installation of the RIGID Industries 2020+ FORD SUPER DUTY A-Pillar Mount Kit. This document provides a step-by-step guide on how to install the brackets on your vehicle and mount the lights, including removal of factory parts, the plastic cowl and installing the brackets. If you have any questions about the installation process, please feel free to ask!
  • What tools are required for installation?
    What is included in the product?
    Do the lights come with the kit?
    What should I do before beginning any installation process?
    What is the first installation step?
INSTALLATION INSTRUCTIONS
- (1) Driver Side Bracket
- (1) Passenger Side Bracket
*Lights sold seperately.
- 10mm socket
- 13mm socket
2020+ FORD SUPER DUTY A-PILLAR MOUNT KIT
PRODUCTS INCLUDE: RECOMMENDED TOOLS:
Move plastic cowl out of the way by removing windshield wiper, antenna, and disengaging plastic
clips holding the cowl in place. Remove windshield wipers using the lever at the base of the wiper.
STEP: 3
Open the vehicle’s
hood and locate the
hood hinges, remove
two factory bolts
using a 13mm socket.
STEP: 1
IMPORTANT
THANK YOU FOR PURCHASING RIGID INDUSTRIES’ PRODUCTS FOR YOUR VEHICLE.
Please read through all of these Instructions and tips before proceeding with the installation.
We do our best to provide a simple installation process for all applications however a
professional installation is always recommended.
Always disconnect any power sources connected to your vehicle before servicing fuses or
electrical systems.
Install bracket brace
onto main bracket
using supplied M6
bolt and M6 U-Nut.
Do not fully tighten.
STEP: 2
INSTALLATION INSTRUCTIONS
Install bracket onto vehicle by aligning the bolt holes and re-install factory bolts. Do not fully
tighten.
STEP: 4
Remove factory bolt under the
plastic cowl using a 13mm
socket. Install secondary support
bracket and re-install factory
bolt. Install supplied M8 carriage
bolt, washer, and lock nut to
secure support bracket to main
assembly. Do not fully tighten.
STEP: 5
Your installation is now complete.
Welcome to the Rigid Nation!
WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty 779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337
www.rigidindustries.com
RIGID and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC, a Delaware limited
liability company d/b/a Rigid Industries.
11-14190-A
Tighten all hardware and repeat steps
1-5 on opposite side of vehicle.
STEP: 6
Re-install cowl, antenna, and windshield
wipers. Install assembled light on the
bracket and install wiring per the
instructions supplied with the light.
STEP: 7
/