Rigid Industries 20641 Installation guide

Brand
Rigid Industries
Model
20641
Category
Wall & ceiling mounts accessories
Type
Installation guide
IGNITE FLUSH MOUNT
BACK UP LIGHT KIT
INSTALLATION INSTRUCTIONS
Always disconnect any power sources connected to your vehicle
before servicing fuses or electrical systems. Professional installation is recommended.
Note: location should be a ξ€Ÿat vertical surface on the rear of the vehicle.
WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty
779 N Colorado St, Gilbert, AZ 85233 β€’ 855-760-5337
www.rigidindustries.com
Ignite, and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC,
a Delaware limited liability company d/b/a Rigid Industries.
1. Use 1.75” diameter hole saw for main hole. Place light into hole and mark locations for
mount screws. Use 3/16” drill bit for mount screw holes.
2. Install lights using provided hardware.
3. Wiring: Route cables behind bumper, trim excess, connect to factory reverse light wires.
Take care to avoid any heat sources & sharp or abrasive surfaces.
4. Reconnect power source, place your vehicle in reverse and ensure lights turn on.
Use This Template For
Accuracy When Using Hole Saw
  • Page 1 1

Rigid Industries 20641 Installation guide

Brand
Rigid Industries
Model
20641
Category
Wall & ceiling mounts accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents