PAC BKTOYK993 User manual

PAC
Brand
PAC
Model
BKTOYK993
Category
Car kits
Type
User manual

This manual is also suitable for

PAC BKTOYK993 is a dash kit for 2007-2012 Toyota Yaris vehicles. It allows you to install a single or double DIN aftermarket radio in your vehicle. The kit includes all the necessary hardware and instructions for a quick and easy installation.

With PAC BKTOYK993, you can enjoy your favorite music, podcasts, and audiobooks on the go. You can also use the kit to add a backup camera or other accessories to your vehicle.

Here are some of the benefits of using PAC BKTOYK993:

  • Easy installation: The kit comes with all the necessary hardware and instructions, so you can install it yourself in just a few minutes.

PAC BKTOYK993 is a dash kit for 2007-2012 Toyota Yaris vehicles. It allows you to install a single or double DIN aftermarket radio in your vehicle. The kit includes all the necessary hardware and instructions for a quick and easy installation.

With PAC BKTOYK993, you can enjoy your favorite music, podcasts, and audiobooks on the go. You can also use the kit to add a backup camera or other accessories to your vehicle.

Here are some of the benefits of using PAC BKTOYK993:

  • Easy installation: The kit comes with all the necessary hardware and instructions, so you can install it yourself in just a few minutes.
CUSTOMER HELP LINE
USA 800-323-4329 • Canada 800-245-8777
TOYK993 Mounting Kit
Toyota
2007-12 YARIS
VEHICLE APPLICATIONS
iTOYK969
Automotive Products Division
1040 Avenida Acaso • Camarillo, CA 93012, U.S.A.
USA Sales (800) 336-6500 • Canada Sales (888) 922-3006 • USA Fax (805) 388-7950
For information about other accessories visit our website at:
http://www.americaninternational.net
For information about other American International automotive
accessories visit our website at:
http://www.americaninternational.net
©2012 AMERICAN INTERNATIONAL INDUSTRIES, INC.
TECH Ver. 4/12 PRINT Ver. 4/12
2
DIN MOUNT INSTRUCTIONS
1. Follow instructions from steps 1&2 of ISO mount instructions below.
2. Insert DIN sleeve from your new radio into the upper section of the installation kit.
(This DIN sleeve comes with all new radios and slides off the back of the radio)
3. Depress the tabs from inside the sleeves opening upward, outward, and downward
to secure sleeve to the installation kit.
4. Install radio into sleeve and lock into place.
5. SUGGESTED...Support rear of radio with back strap.
Optional use Trim Ring (ITR-969) may be used on some radios if desired.
Due to the movement of some faces on some radios our ISO Trim Ring may not be able
to be used. You may also ISO mount your radio.
Your new radio must have a trim ring around the face of the radio that is designed to be
easily removed. Consult your radio owner’s manual.
ITR-993
Trim Ring
(Optional Use)
DIN Sleeve
7
NOTES
54
1. Starting from lower edges, unclip the left and right side trims from around the radio
and climate controls, disconnect the attached harnesses and remove trims.
2. Carefully unclip and pry forward the lower edge of the instrument gauge trim bezel.
3. Carefully unclip and pull forward the Radio/Vent trim bezel and remove.
4. Remove the (4) Phillips screws securing the radio to the sub-dash.
5. Pull radio forward, disconnect the attached wire harness and antenna lead and
remove radio.
DASH DISASSEMBLY
2007-2009 TOYOTA YARIS - 3 DOOR LIFTBACK ONLY
IMBY3-993L
IMBY3-993R
1. Prepare mounting brackets as shown below.
FOR ISO or DIN MOUNT APPLICATIONS SEE PAGE 2 & 3
KIT ASSEMBLY
REMOVE SHADED MOUNTING
TABS ON BOTH LEFT AND
RIGHT SIDES OF KIT
1. Carefully unclip and remove the soft trim piece from around the radio, airbag
light/hazard button and passenger side air vent.
3. Carefully unclip and pry forward the radio trim bezel.
5. Remove the (4) Phillips screws securing the radio to the sub-dash.
6. Pull radio forward, disconnect the attached wire harness and antenna lead
and remove radio.
DASH DISASSEMBLY
2
012 TOYOTA YARIS
KIT ASSEMBLY
FOR ISO or DIN MOUNT APPLICATIONS SEE PAGE 2 & 3
ITR 993
REMOVE SHADED MOUNTING
TABS ON BOTH LEFT AND
RIGHT SIDES OF KIT
6 3
1. Carefully unclip and remove the bottom edge trim piece from below the climate
control module.
2. Starting from lower edges, unclip the left and right side trims from around the radio
and climate controls and remove.
3. Carefully unclip and pry forward the lower edge of the instrument gauge trim bezel.
4. Carefully unclip and pull forward the Radio/Vent trim bezel, disconnect the attached
harness and remove bezel.
5. Remove the (4) Phillips screws securing the radio to the sub-dash.
6. Pull radio forward, disconnect the attached wire harness and antenna lead and
remove radio.
DASH DISASSEMBLY
2007-2011 TOYOTA YARIS - 4 DOOR SEDAN ONLY & 5 DOOR HATCHBACK
Excluding 3” Radio Displays)
ITR 993
IMBY4-993L
IMBY4-993R
KIT ASSEMBLY
FOR ISO or DIN MOUNT APPLICATIONS SEE PAGE 2 & 3
REMOVE SHADED MOUNTING
TABS ON BOTH LEFT AND
RIGHT SIDES OF KIT
ISO MOUNT INSTALLATION INSTRUCTIONS
Note: Some radio faces are larger in size than the ITR-969 Trim Ring allows.
You may need to file the Trim Ring opening larger for some radios.
1. Attach the left and right side brackets to the main bracket. See illustration below.
2. Attach left and right side brackets to the rear of the pocket using screws supplied w/kit.
3. Attach ISO Mount Spacers to the inside of upper section on
both Left & Right mounting brackets as shown in Figure A.
4. Slide radio into kit from rear & attach to ISO mounting
brackets using screws supplied with radio (do not tighten
screws at this time). (Be sure the length of the screws
DO NOT touch any electrical parts inside radio, some
screws may need to be shortened.)
5. Slide radio forward or backward for your desired look and
then tighten the mounting screws. Use ISO trim ring
when possible.
6. SUGGESTED...Attach rear support strap
(supplied with radio) to rear of pocket and
to rear of radio.
NOTE: Optional ISO trim ring (ITR-969 included) may
be used in place of after-market radio’s trim ring.
ITR-993
Trim Ring
(Optional Use)
Fig. A
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

PAC BKTOYK993 User manual

PAC
Brand
PAC
Model
BKTOYK993
Category
Car kits
Type
User manual
This manual is also suitable for

PAC BKTOYK993 is a dash kit for 2007-2012 Toyota Yaris vehicles. It allows you to install a single or double DIN aftermarket radio in your vehicle. The kit includes all the necessary hardware and instructions for a quick and easy installation.

With PAC BKTOYK993, you can enjoy your favorite music, podcasts, and audiobooks on the go. You can also use the kit to add a backup camera or other accessories to your vehicle.

Here are some of the benefits of using PAC BKTOYK993:

  • Easy installation: The kit comes with all the necessary hardware and instructions, so you can install it yourself in just a few minutes.
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents