American International HYNK1133 User manual

Type
User manual

American International HYNK1133 is a car stereo installation kit designed for 2006-2011 Hyundai Azera vehicles. It allows for the installation of a single ISO mount or double DIN mount aftermarket radio. The kit includes left and right mounting brackets, a pocket, and all necessary hardware for installation. With this kit, you can easily upgrade your car's audio system with a new radio that fits seamlessly into your dashboard.

American International HYNK1133 is a car stereo installation kit designed for 2006-2011 Hyundai Azera vehicles. It allows for the installation of a single ISO mount or double DIN mount aftermarket radio. The kit includes left and right mounting brackets, a pocket, and all necessary hardware for installation. With this kit, you can easily upgrade your car's audio system with a new radio that fits seamlessly into your dashboard.

Ameri,an
International
Car
Stereo
Installation
Ki
ts
&
Accessories
~
0~
0~
(;J)
VEHICLE
APPLICATIONS
Hyundai
2006-11 AZERA
©2012 AMERICAN INTERNATIONAL INDUSTRIES, INC.
....
■-
=-:
z::n
C
■-
....
C
:::s
b
C,
==
cw:»
cw:»
...
-
z:
-
TECH Ver.
7/
12 PRINT Ver. 6/12
2006-2011
HYUNDAI
AZERA
DASH
DISASSEMBLY
1 . Remove the (2) Phillips screws from below the bottom edge of the Radio/ Climate
control trim bezel assembly.
2. Carefully unclip and pry forward the
thin-
trim panel that is located at the right of the
instrument gauges and extends to above the right side dash vent.
3. Remove the (3) Phillips screws securing the top edge of the Radio/Climate control
trim bezel assembly.
4. Open the driver's door and remove the side dash trim panel.
5.
Remove the single Phillips screw securing the left edge of the lower driver's knee
panel cover.
6. Remove the (2) Phillips screws securing the lower edges of the drivers side knee
panel cover.
7. Carefully pry forward the lower drivers side knee panel and lay out of the way.
8. Remove the single Phillips screw located directly below the ignition securing the left
edge of the Radio/Climate control trim assembly.
9. Carefully starting at the top edge and working your way counter clockwise, pry the
entire radio/Climate control trim assembly forward, disconnect all attached harnesses
and remove assembly.
10. Remove the
(4)
Phillips screws securing the radio to the sub-dash, pull radio forward
and disconnect the wire harness and antenna lead and remove radio.
KIT
ASSEMBLY
INSTRUCTIONS
Single
ISO
Mount
Applications
1.
This kit is an (ISO) mounting kit only.
2. The mounting sleeve of your new radio and trim ring cannot be used when
ISO mounting
an
aftermarket radio. Your radio must have a removeable trim ring.
3.
Insert left and right mounting brackets to rear of kit as shown
in
Figure A
and secure to rear of kit fascia using
(4)
small phillips screws included
in
kit.
4. Insert pocket irito lower section of kit from rear & lock into slots of mounting brackets.
5.
Insert ISO mountable radio between ISO mount brackets and loosely
attach to sides of radio using screws provided with radio when possible
or screws supplied with kit.
6. Slide radio forward or backward for desired look and tighten screws.
Double
DIN
Mount
Applications
1.
Attach the left and right side brackets to the main frame. See Figure B on page 3.
2. Insert ISO mountable radio between ISO mount brackets from the back and loosely
attach to sides of radio using screws provided with radio when possible
or
hardware
included with kit.
3. Slide radio component forward or backward for desired look and tighten screws.
4.
Attach a rear support bracket to the rear of the new radio and adjust as necessary
to attach to the rear support stud located on the back of the pocket using the small
phillips screw supplied with kit.
NOTE:
Test the movement of the face of the radio prior to securing the kit to the
sub-dash, you may need to re-adjust the radio forward for proper clearance.
2
fig. A
Fig.
B
~
()~
r;;;P
"1111,,
Fr.
a,,,e
Left
IMB·1133L
I
I
I
I
I I
~~~~~
~'/
Left
IMB·1133L
I .
I I
I I
I I
I I
I I
I I
I I
I I
I I
I
I
I
I
I
I
I
I I
I I
I
I
I
I
I
~
I~
b
Right
Right
IMB-1133R
IMB·1133R
3
For
information
about
other
American
International
automotive
accessories
visit
our
website
at:
http://www.americaninternational.net
I
.I
'I
e,
American
International
Automotive
Products
Division
1040
Avenida
Acaso
Camarillo,
CA
93012
,
U.S.A.
USA
Sales
(800)
336-6500
Canada
Sales
(888)
922-3006
USA
Fax
(805)
388-7950
CUSTOMER
HELP
LINE
.
USA
800-323-4329
Canada
800-245-8777
,111
NK
11
n
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

American International HYNK1133 User manual

Type
User manual

American International HYNK1133 is a car stereo installation kit designed for 2006-2011 Hyundai Azera vehicles. It allows for the installation of a single ISO mount or double DIN mount aftermarket radio. The kit includes left and right mounting brackets, a pocket, and all necessary hardware for installation. With this kit, you can easily upgrade your car's audio system with a new radio that fits seamlessly into your dashboard.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI