2. Intermec
  3. 825-196 Series

Intermec 825-196 Series, PW50 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Intermec 825-196 Series Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The handstrap (P/N 825-196-xxx) provides you with a convenient way to carry your
PW50 printer. The handstrap kit contains these items:
• Handstrap accessory
• These instructions
To attach the handstrap
1 Release the strap from the adjuster, and remove the strap from the VELCRO
pad.
2 Insert the strap through the PW50 and VELCRO pad. Make sure the D-ring and
adjuster are oriented as shown at the top of the PW50.
PW
50
Handstrap Instructions
Note: VELCRO is a trademark of Velcro Industries B.V.
Strap
D-ring
Adjuster
VELCRO pad
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2008 Intermec Technologies
Corporation. All rights reserved.
PW50 Handstrap Instructions
*943-159-001*
P/N 943-159-001
3 Place the strap on the VELCRO pad, and route the strap through the adjuster
and D-ring as shown.
4 Close the VELCRO pad over the strap. You are now ready to use the printer with
the handstrap.
5 (Optional) Install another handstrap on the other side of the PW50.
Strap
D-ring
VELCRO pad
Adjuster
/